Kampa AIR Break Pro 3 User manual

User Guide
AIRBREAKPRO-UM-10-18
For Models: AIR Break Pro 3 (WB0004)
AIR Break Pro 5 (WB0005)

Thank you for purchasing the Kampa AIR Break Pro windbreak. Please read
these instructions carefully before attempting to set up and retain for future
reference. If used properly, your windbreak should give you years of trouble
free use. We recommend that your windbreak is insured against accidental and
storm damage as this is not covered by the warranty.
The AIR Break Pro has an angular design and can be set up with both or one
end attached to the awning. The AIR Break Pro can also be used freestanding.
Included in the bag: AIR Break Pro, Pegs and Guy Lines.
If you are missing any parts please contact your supplying retailer.
This windbreak is designed for use in light to moderate weather. During strong
winds we recommend that you take your windbreak down. The windbreak is
designed for touring use; it is not designed for static or commercial use.
We recommend a trial run before using your windbreak for the first time. This
will allow you to familiarise yourself with the windbreak, its set up and any
limitations the windbreak may have for your particular use.
Introduction
Information
Fabrics can be weakened by prolonged exposure to sunlight. Under normal
holiday use your windbreak will give long service but use for extended
periods in strong sunlight will soon cause deterioration. In those cases it would
be wise to use a site as shaded as possible. UV degradation is not covered
under the warranty. The warranty does not cover product used on permanent
sites, displays or for commercial purposes.
UV Degradation
Materials & Components
Air fully and ensure it is totally dry before packing away. Store in a well-ventilated
dry place. Mildew will develop surprisingly quickly if the windbreak packed
away wet/damp. Any dirt can be washed using clean water and a soft brush.
Do not scrub and never use detergents.
The AirPoles do not need any maintenance but should be protected from
damage during storage. Damage due to improper use, wind damage or neglect
is not covered under the warranty. Have any damage repaired at the first
opportunity.
Care

1. Position and attach the AIR Break
Pro to the awning at one or both
ends.
2. If fitted, clip the AIR Break Pro
directly onto the awning and
tighten (see Image 1). Alternatively
utilise the QuickPitch attachment
point(s) by looping the AIR Break
Pro adjustable strap(s) through
them. Pull the strap tight to secure
(see Image 2).
3. Locate the inflation valve on the
central panel. Unscrew the top
cap and attach the pump nozzle
(see Image 3).
4. Once inflated, push or pull the
AIR Break Pro up, allowing the
AirPoles to assume their
correct shape (see Image
4).
5. Inflate the AIR Break Pro
from the inflation valve.
The ideal inflation pressure
is 9psi (0.62 bar).
Set-Up and Take Down
If you are using the AIR Break Pro
freestanding skip Steps 1 and 2 1
2
4
3
WARNING!
If present, never open the zip
on an AirPole inner sleeve
whilst inflated as this will result
in the bladder bursting.

www.kampa.co.uk
© 2018 Kampa UK Limited, Witham, CM8 3EU
Kampa UK Limited accept no liability for any form of consequential loss whatsoever. Any sizes and specifications quoted are approximate and are
given as an indication only. Kampa UK Limited reserves the right to alter specifications as considered necessary and without notice.
AIRBREAKPRO-UM-10-18
5
6
7
6. Peg down the AIR Break Pro,
start from the ends closest to the
awning then continue to peg each
corner down (see Image 5).
7. Clip on and peg out the external
guy lines (see Image 6).
8. If you are using the AIR Break Pro
freestanding, clip guy lines onto
both sides and peg down to
secure its position.
Take Down
1. Deflate by turning the taps on the
grey deflation valves located at
each end of the AIR Break Pro
(see Image 7).
2. Unpeg all pegging points and
unclip all guy lines.
3. Fold and roll towards open
deflation valves, forcing any
remaining air out.
4. Roll the AIR Break Pro into the
carry bag, zip up and tighten the
compression straps.