KAN-therm B4012 User manual

P ck ge contents: power supply strip (1 pc.), operation manual (1pc.), rule (1 pc.).
S fety directions
Every electric work should be done by an authorized person according to regulations in force and also to recommendations of a local power station.
Before installation work switch off power supply!
S fety rules:
Before removing a cover switch off supply voltage
For cleaning power supply strip use a dry cloth.
In c se of f ilure bsolutely cut off whole temper ture control system in room from power supply network..
12/2009 © Copyright KAN Sp z o.o. All rights reserved. Text, images and their arrangement in KAN publication are protected by proprietor’s rights.
POWER SUPPLY STRIP
OPERATION MANUAL
B2012/B4012 (without pump module)
B2022/B4022 (with pump module)
ISO 9001 : 2000
Design ted use nd working principle
A power supply strip is used to connect temperature control devices (actuators and thermostats) in an easy, simple and handy way.
KAN
is not responsible for results of use non-conforming to its design ted use.
Connecting PS strip to power network
Technic l specific tions
PS strip code: B2012/B2022 B4012/B4022
Operation voltage 230V 24V
ax. power consumption 50W 50W
Supply voltage 230V AC, 5A 230V AC, 5A
Fuse T 4A H T 2A H
ax. number of thermostats 66
ax. number of actuators 12 12
Optional heating programs 22
Protection class II II
Degree of protection IP20 IP20
Working temperature from 0 to 60 C from 0 to 60°C
Storage temperature from -25 to 60°C from -25 to 60°C
Relative humidity (no condensation) max 80% max 80%
Dimensions (mm) 41 / 325 / 74,5 41 / 333 / 74,5
Wieght 350g 350g
Recommended wire sections: 0,75 - 1,5 mm² 0,75 - 1,5 mm²
www.ka .com.pl

Electric connection recommend tion (Fig.1)
To fix a cable at the point of entry into the PS strip use latches to be broken off (at the bottom of a PS strip). Connect cables to terminals.
INPUT (IN) OUTPUT (OUT)
Connection of room thermost ts nd electric ctu tors (Fig. 2)
1. One or two electric actuators connected to one zone (standard).
2. Three or four electric actuators connected to one zone (option).
Timer connection (Fig. 3)
1. External timer connection with maximal two control ciruits (A or B).
2. Room thermostat connection with a timer.
Room thermost t connection with timer sign l. (Fig. 4)
Connect A or B command signal to a room thermostat output - horizontal channel.
Pump connection (Fig. 5)
Having a pump connected to a PS strip it is possible to control it, i.e. to switch it ON/OFF depend on room temperature.
Switching off a pump takes place automatically, if all electric actuators get closed. Switching on is also automatically, if any
of electric actuator gets open.
Fig.5
Fig.3Fig.2 Fig.4
www.ka .com.pl
2008 © Copyright KAN Sp z o.o. All rights reserved.
Fig.1