Kantek PowerCentral CM1100 User manual

INSTALLATION NOTES:
• Do not use the unit outdoors.
• Do not install in poorly ventilated location
or near flammable materials.
• Do not put unit in a location where it can get wet.
• Power cords should be completely plugged in.
• Replace the rear cover before use.
• The total current should not exceed 15A.
• Should not exceed 1,875W in total.
PRODUCT SPECIFICATIONS:
Model CM1100
Input AC 125V 50 / 60 Hz
Rated Power 1,875W(125V, 15A)
USB Input 125V AC (50/60HZ)
USB Output 5V DC | MAX 3.1A
Surge 600J 15,000A
Outlets 5 Outlets + 3 USB Ports
Size 11⁄w x 6⁄d x 3⁄h inches
Cable Length 6⁄ ft.
kantek.com
Cable Management Power Hub Stand
CM1100

BACKSIDE
CABLE OUTLET
VENTILATION
HOLES
BACK COVER
SECURING HOOK
INDIVIDUAL
POWER SWITCHES
USB
CHARGER
Smart Phone / Tablet Stand
MAIN POWER
SWITCH
Back Cover
 How to use
Front Side
2. Place the CM1100 face down
in a vertical position. Firmly
plug in power cords of devices
you’d like to connect.
1. Remove the back cover.
3. Organize cords by placing
excess cable into the cabinet.
Be sure to leave enough slack
to reach your devices.
4. Align the cables into the cable
outlet holes, and close the
cover from the bottom.
8. Plug CM1100 into AC
power for use.
7. Attach the sticker to the
corresponding power button
of the connected device.
6. Select device ID labels for each
connected device.
5. After lifting slightly up the
detachment groove the
back cover, close completely
by pushing the upper part
of the back cover.
Back Side
SIDE CABLE
OUTLET
POWER
CORD
OUTLETS FOR
DEVICES
CIRCUIT
BREAKER