Kärcher CV 38/2 User manual

QUICKSTART
5.964-157.0 01/15
몇WARNING
These are only brief instructions! Please read the operating instructions accompanying
the device prior to using or maintaining the device.
The non-compliance with the operating and safety instructions may lead to damage
of the appliance and to risks for the operator and other persons.
Start up
1ACV38/2
BCV48/2
2A
D
B
E
CA Swivel cable hook upward and completely
remove the mains cable from the device.
B Open the holder of the handle.
C Adjust the handle.
D Close the holder of the handle.
E Tilt the appliance backwards and drive it
to the place of use.
Operation
3A B Turning on the Appliance
A Plug in the mains plug.
B Switch on the appliance at the main switch.
CV 38/2 – CV 48/2

QUICKSTART
5.964-157.0 01/15
4ABCBrush roller operation
ATTENTION
Risk of damage to the floor covering.
Do not operate the appliance on the spot.
A Set the pile height via the adjustment knob
of the brush head.
B Push the unlocking mechanism of the brush
head and tilt the handle backwards.
Brush motor switches on.
Perform the cleaning operation.
C The electronic brush control continuously
monitors the work of the brush roller.
No light
Brush roller is working properly.
Orange light is glowing
Set the adjustment knob for pile height to the
lower pile height.
Orange light also glows at lowest level
Replace the brush roller.
5ABCSuction pipe operation
ATTENTION
When you vacuum with the suction hose, the
device must lock into place in the home position
in order to allow the brush motor to switch off
A Bring the handle in a vertical position and
snap it into place on the brush head.
B Pull the suction pipe out toward the top.
C Perform the cleaning operation.
Finish operation
6A B Turn off the appliance.
A Switch off the appliance at the main switch.
B Pull out the mains plug.
Wind the mains cable around the cable
holders.
Operation