Press "MODE" button to select the Memory Mode. "Days Record" will appear on the bottom of the LCD.
The upper line of the display will show Memory data, press "SET" to read the record by sequence as follow:
Step Distance Calorie Step time
The unit can be stored up to 7 days record, check each day record by pressing the "RESET" button
Press "MODE" button to select the Total Mode. "Total" & "Step" will appear on the top of the LCD.
The upper line of the display will show the Total data you have walked from the beginning.
Press "SET" to read the details by sequence as follow:
Step Distance Calorie Step time
To delete the data, hold "Reset" button for 2 seconds.
Real time always appear on the bottom of the LCD.
Input your daily target step at Functional Setting, you can select from 100 to 99,000 steps.
You can keep checking on the percentage of the target from the target reaching bar indicator on the left side of the display.
When you reach the target, the target bar indicator will flash with "Bi Bi" sound to remind you.
To set your Target Step, please refer to the Functional Setting column.
* When the Target Bar Indicator is full means you have succeed and reached the Daily Target.
If you want to set another target in the same day AFTER the target is reached,
please reset the step record before inputting the new target data.
The pedometer will keep your last setting in memory as everyday Target.
Power Saving Function will be activated whenever there is no further key input and no motion signal is detected over 3 minutes.
To resume work, press any button or it will automatically resume work when the sensor detects new motion signal.
Display will show the previous data.
~ Connect the Pedometer to your computer by using the USB cable;
~ When the Pedometer is connected to the PC, "PC" will appears on the display of the Pedometer;
~ Insert the program CD into your computer;
~ Copy the program " Walknote_lite" into your PC.
~ Open the "Walknote_lite" program from your PC.
~ You can input your inforamtion in the "User Page" when frist use. Then save as record;
~ When the Pedometer is connected to the PC, "PC" will appears on the display of the Pedometer;
~ When you upload the new record to your computer, please select the correct user name and click "OK",
cover the old record and synchronize the new data to computer.
~ You can check everyday record (Step, Distance, Calorie counter, Walking Time, Total Step & Target bar) from the "TODAY" folde
~ You can check the Step, Distance, Calorie counter and Walking Time record in Daily, Weekly, Monthly & Yearly basis respectively
from the "RECORD" folder.
~ You can save those data as a CVS file for your computer record and send them to your doctor or health consultant.
~ The clock of the Pedometer will be set according to your computer clock after every synchronized.
" " Indicates battery power is low.
Please refer to the following diagram to replace the battery with proper type when display dims. (Battery type: CR2032)
Step 1. Remove the screw from the battery door of the pedometer by using a small Philips screwdriver.
Step 2. Remove the battery door as shown in the Diagram A.
Step 3. Put the new battery in correct polarity. Replace with CR-2032 battery x 1pc.
Step 4. Close the battery door as shown in the Diagram B.
Step 5. Don't forget to tighten the screw on the battery door.
NOTE: When the battery compartment is opened or battery is replaced, all data in the pedometer will be reset.
Memory Mode
Total Mode
Daily Target Step
Power Saving Function
Battery Replacement
1
2
1
2
Diagram A.
Removing the battery door.
(1) Slide out the battery door a bit;
(2) Tilt up the battery door and
take out toward right side.
Diagram B.
Closing the battery door
(1) Insert the side lip of the battery
door into the cabinet;
(2) Slide in the battery door to close.
Installation of the USB driver program
Connect the Pedometer to the PC
