KC HiLiTES 9801/TYPE 1 User manual

WIRING INSTRUCTIONS
Step 1: Mount the Rear Facing Chase Bar to your desired
location using the included hardware.
Step 2: Mount the Control Module to your desired location
(hardware not included).
Step 3: Plug in a 16-pin Wiring Lead (2 were supplied, 1 is
extra) into the left port on the Control Module.
Step 4: Connect the Positive (RED) & Ground (BLK) of both
the Chase Bar Wiring Harness & Control Module Harness to
the 12V Battery (as shown in the Wiring Diagram).
Step 5: Connect the Green wire from the Chase Bar to the
Green wire (A Pin) of the Control Module. Connect the
White wire from the Chase Bar to the White wire (B Pin)
of the Control Module. These connections send the control
signals to the light bar.
Step 6: Use Chase Light Function Diagram to nalize wiring
for the various chase light functions.
For more thorough installation instructions, please visit:
https://support.kchilites.com (Installations)
QUICK INSTALLATION GUIDE
KC CHASE LIGHT
9801/TYPE 1 & 9802/TYPE 2 (RACE ONLY)
Copyright 2022 KC HiLiTES, Inc. Rev:09162022 - KC3265EI_REV3
MODULE 1
MODULE 2
MODULE 3
MODULE 4
MODULE 5
MODULE 6

QUICK INSTALLATION GUIDE
KC CHASE LIGHT
9801/TYPE 1 & 9802/TYPE 2 (RACE ONLY)
Copyright 2022 KC HiLiTES, Inc. Rev:09162022 - KC3265EI_REV3
MODULE 1
MODULE 2
MODULE 3
MODULE 4
MODULE 5
MODULE 6