KegLand Cannular KL15769 User manual

Page 1of 4www.KegLand.com.au Last Updated 11/10/2021 12:46 PM
Cannular Compact Semi-Auto
Canning Machine
Seaming Start/End Point Alignment
KegLand Distribution PTY LTD
www.KegLand.com.au

Cannular Semi-Auto Instruction Manual
Page 2of 4www.KegLand.com.au Last Updated 11/10/2021 12:46 PM
The Semi-Automatic Compact Cannular Canning Machine actuates the first operation and second
operation rollers automatically ensuring a consistent seam on every can.
This unit relies on a rotating cam contacting a microswitch to indicate when the machine has
reached the endpoint of the seaming rotation and hence the start point of the next seaming
rotation. The activation of this microswitch results in the motor turning off.
The motor should be turned off when the second operation roller has moved away from the chuck
and before the first operation roller begins moving towards the chuck. Therefore, the motor should
turn off when the second operation roller has finished compressing the seam and both the first and
second operation rollers are at the furthest point away from the chuck.
If you notice that your rollers stop at the wrong position then this instruction manual will guide you
through how to adjust the Cannular such that rollers are at their correct position when the
microswitch is activated.

Page 3of 4www.KegLand.com.au Last Updated 11/10/2021 12:46 PM
Step 1. Loosen the two grub screws which hold the lower cam (situated behind the chuck) to the
camshaft.
Step 2. Inch the machine until the upper cam (situated below the blue cog) is contacting the spring-
loaded lever of the microswitch (this can be identified by an audible click

Page 4of 4www.KegLand.com.au Last Updated 11/10/2021 12:46 PM
Step 4. You will notice two red lines on the lower cam (each line is situated 180 degrees from each
other). One red line has the grub screw to its left, the other has the grub screw to its right.
Align the lower cam such that the red line which has the grub screw on its right is lined up with the
left arrow on the cannular body, as shown below. This ensures that the entire second operation
seaming process is completed and the micro switch is activated as the second operation roller begins
moving away from the chuck.
Note: you may need to hold the 2nd operation roller towards the chuck while aligning the cam to
prevent the 2nd operation roller from rotating the cam.
Step 5. Tighten both grub screws on the lower cam and confirm the motor is stopping with the
rollers in their correct final positions.