Kelvix FX3D User manual

090822JH
1/2 | 800.789.3810 | [email protected]
FX3D
Angled Mounting Clip Installs
SAFETY PRECAUTIONS

Remove from power
source immediately if any
damage is found in the
LED strip or cabling.

Product is NOT to be
modied in the eld.
Modications will void ETL
listing and warranty.

The rst 2.36" (60mm) of
the cable should maintain
its natural state before any
bending occurs.

Ensure all electrical
connections are insulated
and secure before
applying power.

Do not bend product
smaller than bending
diameter: 9.40" (300mm).
9.40"

Connect power feed to
appropriate power source
or controls.

Do not power up while
coiled for over 30
minutes. This may lead to
overheating and damage.

The use of third-party
accessories must be
pre-approved by Kelvix.
Failure to do so will void
manufacturer warranty.

2.36"

090822JH
2/2 | 800.789.3810 | [email protected]
FX3D
Angled Mounting Clip Installs








1 2
3 4