Ken-Tec Microspeak MSA1 User manual

-1-
Ken-Tec Products
Microspeak PIR Motion Sensor Message
Announcer
MSA1

-2-
Features
※Small size, high-quality MP3 audio playback.
※High and Low volume levels - switch selectable
※Human body sensor to trigger message playback, sensing range of up to 4 m
※2 Mb internal flash memory
※Multi message capability programmable for single message playback or sequential playback
※3 × AAA battery-powered, built-in 0.5-watt, 8 ohm speaker
※10-20 hours of continuous playback
※Dimensions:60mm*90mm*26.6mm
※Weight:62g
Application:
Door security reminder for the elderly, Customer personalized welcome, Mind the step, No smoking reminder, Wash
your hands reminder, Health & Safety warning and reminders, Building site reminders, Wet paint reminders, Pull /
push the door. etc
Function Instruction
Item Description Function
Volume &Power Switch
Down Turn Off Power Supply
Middle Low Volume
Up High Volume
Indicator LED
Off Power off& No Movement detected
On Message playback
Button A
Short Press Previous Message
Long Press, LED Flashes Mode Switch
Button B
Short Press Next Message
Long Press, LED Flashes Reading message from SD card
PIR Movement
Sensor
Mini SD Card Slot
Volume &Power
Switch
Button B
Button A
Indicator LED

-3-
Update Voice Files
Step1: Copy the files into root directory of Mini SD Card from computer
Step2: Plug the Mini SD card into Mini SD Card Slot
Step3: Power on and press and hold Button B until the LED flashes to indicate that files are being copied from the mini
SD card into built-in Flash
*Note: The voice file size cannot exceed the capacity of the built-in Flash
After file update, turn off power and remove Mini SD card. Power on and new message will play.
Mode Switch
Long press of Button A during message playback, until LED flashes will change the playback from single message to
multiple messages to play in sequence (if multiple messages programmed) Long press again will revert to single
message playback. Short press of button B during playback will change message to the next message stored on the
built-in flash
Accessories
Item Name Num Unit Picture Standard
configuration
1
MSA1
Player 1 PCS
√
2
Mounting
Bracket
1 Set
√
3 3A battery 3 PCS
Not Supplied
Ken-Tec Products Tel: [phone]
The Close Fax: [phone]
YewTreeLane Email:[e-mail]
Bradley Web:www.ktpuk.com
Derbyshire DE6 1PG