Kenco Barrier Lift User manual

KENCO BARRIER LIFT®Alignment Leg Installation Instructions 1
170 State Route 271
Ligonier, PA 15658
1-800-653-6069
Barrier Lift
Alignment Leg Installation Instructions
Attachment Solutions

KENCO BARRIER LIFT®Alignment Leg Installation Instructions 2
170 State Route 271
Ligonier, PA 15658
1-800-653-6069
Section I. Identification of Major Components
Section II. Installation and Assembly
1. Disassemble the alignment leg assembly by removing the Tie Plate and
separating the Outer Brackets from the Middle Bracket.
2. Suspend the lifter.
3. Slide the middle bracket through the lifter on top of the center-link pivot pins
with the slots facing down, capturing the pivot pins.
4. Slide the long end of the L-shaped outer brackets through the lifter, under the
center-link pivot pins with the slots facing up. (Place one outer bracket on each
side of the middle bracket. All slots and bolt holes must line up with each
other.)
5. Lift the outer brackets (on the long slotted end) lining up the bolt holes on the
middle and outer brackets. Install the bolt sandwiching the middle bracket
between the outers. Lift the outer brackets on the opposite end lining up the
holes and install the remaining 2 bolts. (Note: Pivot pins should be captured by
slots and resting in angles on middle bracket.)
6. Locate the tie plate on the short legs of the outer brackets and bolt together.
Middle Bracket
Outer Bracket
Tie Plate
Alignment Dog
Pad Angle
Center Link
Pivot Pin
Note: Nearest arms and Legs removed for clarity