kENDALL 8U-1915-3-001-08 User manual

Tools/Hardware needed:
Screw Driver
and/or Drill
You may also need: Mounng screws
and anchors
Qty 1: Wall Mount Rack
What’s in the box?
Step 1:
Step 2:
1. With a electronic stud nder, locate the exact center
of a wall stud where you would like to mount the
rack. Mark the wall with a pencil where the top of
the wall rack will be.
2. Tape the stencil to the wall lining up your mark with
the arrow on the template. Make sure the template
is level on the wall.
3. We recommend using 2.5” common drywall screws
driven directly into the center of a wood stud.
Screw in the rst screw leaving the head around 1/2
from the wall into template holes 1 and 2.
1. Leaving the template in place, hang both sides on the
screws through the keyhole provided at the top of each
base.
2. Screw in screws 3 and 4 but do not fully ghten. Re-
move the template by pulling from the boom.
Step 3:
1. Add the addional screws and ghten the top and
boom screws.
Qty 1: Wall Mount Template