1. Always ensure the airline pressure is
correctly set to within the equipment's
safety limits 70-110psi (5-8bar).
2. Make sure the
air control valve
is closed before
connecting to
the air supply.
3. Select the most
suitable nozzle for
the job that you are
doing and insert into
the pick-up hose.
4. Insert the nozzle into
the fluid and open
the air control valve
to commence
extraction.
5. Close the control
valve when extraction
is finished.
6. To empty the reservoir,
disconnect from the
air supply, remove
the reservoir cap
and pour into a
suitable container
for transport/storage.
Note:
Dispose of all waste
flui s in accor ance
with the relevant
environmental health
& safety qui elines
SAFETY GUIDELINES
This tool is easy and safe to use following the guidelines opposite.
lAlways wear safety goggles to protect your eyes from splashes
of fluids.
lAlways wear protective gloves when working with any type of
lubricant or fluid (use engine oil is carcinogenic).
lAlways wear ear protection as prolonged exposure may result in
damage to hearing.
lAlways clean out reservoir between uses - do not allow different
fluid types to mix.
2 3
KENNEDY
thoroughly recommen s rea ing these instructions before using this
equipment, even if you have use one before. Rea ing these instructions carefully
an un erstan ing them fully will enable you to perform tasks correctly an will
prevent injury to yourself or someone else.
This equipment has been designed to drain brake fluid, waste oil from the sump of an engine via the dipstick
tube, drain and bleed brake and clutch fluids and to collect spillages of any non-corrosive fluid.
Technical Specifications
Model Number. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FEP010
rder Code . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . KEN 540-4700K
Air Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70-110psi (5-8bar)
Air Consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 180Ltr/min.
Vacuum (maximum) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500mm HG
Reservoir Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10Ltr
Extraction Rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.5Ltr/min.
Air Inlet Size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/
4”BSP
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.8kg
INTRODUCTION
OPERATING INSTRUCTIONS
Reservoir Cap
Air Control
Valve
Exhaust
Pick-up Hose
Nozzles
Air Inlet
