Kerio V300 User manual

Kerio Operator Box
V300

Kerio Operator Box V300
2
1 Purpose
This document is a quick guide for safely installing and implementing Kerio Operator Box Vse-
ries PBX appliances.
2 General Safety Instructions
During installation follow these security instructions:
• The appliance should be placed on a at surface.
• Do not attempt to open or disassemble the appliance for any reason.
• Strictly follow the installation instructions (see section 4).
• Do not place the appliance near a heat source.
• Place the appliance in a ventilated space, making sure that the appliance fans and vents are
unobstructed at all times.
• Do not expose the appliance to liquids of any kind. In the event of liquid intrusion, unplug
the appliance immediately.
• Verify that the voltage and frequency of the power socket matches the values printed on
the power adapter before plugging in the appliance. Use only the power adapter supplied
with the appliance.
• Do not place any items on top of the power cable; keep the power cable away from walk-
ways or other areas where it could pose a tripping hazard.
3 Appliance Description
Kerio Operator Box V300 is a Sub-1U table mountable appliance — see gure 1.
Figure 1 Kerio Operator Box V300 (front)
Feature Description
Serial port Used for connecting to a console with a serial cable
USB ports Input for USB devices
Ethernet network ports Used for connecting to the Internet and the LAN with an
Ethernet cable
Table 1 Kerio Operator Box Features
Ethernet Ports USB PortsSerial Port

3
4 Kerio Operator Box Installation and Conguration
Once a suitable place has been located for the appliance and it has been plugged into a power
outlet according to the safety instructions, it is time to connect it to the network and congure
settings.
1. Connect Ethernet port number 1 to the network using an Ethernet cable.
Note: Alternatively, you can use port number 2 which includes a DHCP client.
2. Turn on the appliance.
3. On the computer you want to use for the Kerio Operator conguration, set the following
TCP/IP parameters:
IP address: 10.10.10.2
Subnet mask: 255.255.255.0
Setting the default gateway and DNS servers is not necessary for the Kerio Operator con-
guration.
4. The Kerio Operator PBX is congured through the Kerio Web Administration interface.
Open a web browser and connect to the Kerio Control Administration web interface using
the following URL:
https://10.10.10.1/admin
5. Ignore the SSL certicate warning.
6. Follow the instructions provided by the wizard and congure the appliance.
Note: For troubleshooting purposes, you can use the serial port to connect the console to
the device. See http://kb.kerio.com/1875 for details.
5 Additional Information
For further assistance with conguration please refer to additional documentation at:
• http://kb.kerio.com/category/kerio-operator/
For online and community based support resources please visit :
• http://www.kerio.com/support
ENQuick Installation Guide

© 2015 Kerio Technologies s.r.o. All rights reserved. www.kerio.com