Kettler 2555 Installation guide

2555 ADIRONDACK FOOTREST
Properly Seated
Washer and Locknut.
Slide washer
onto end of
bolt, then attach
and tighten the
locknut.
1.
Align holes then insert the
1/4 - 20 x 2” bolts.
Made in the U.S.A.
www.kettlerusa.com
[email protected]
Copyright © Kettler USA 309.01
Assembly Instructions
1. Align leg to predrilled holes and insert 1/4-20 x 2” bolts
then clean any plastic residue from the bolt. Slide on washers and
tighten the locknuts with the 7/16” wrench. Repeat to attach the
leg on the other side.
2. Place the cross brace between the legs aligning the predrilled
holes on the end of the cross brace and the footrest legs. Insert
a 1/4-20 x 2” bolt and tighten with phillipshead screwdriver to
secure. Repeat to attach the brace on the other side.
Contents:
(1) Footrest Bed
(2) legs
(1) Cross Brace
(6) 1/4 - 20 x 2” Bolts
(4) Washers
(4) Locknuts
Tools Required:
#3 Phillips Head Screwdriver
7/16” Wrench
Align holes then insert the
1/4 - 20 x 2” bolts.
2.
Locknut Washer 1/4-20 x 2” Bolt

KETTLER® International Inc. • 1355 London Bridge Road • Virginia Beach, VA 23453
www.kettlerusa.com • [email protected]
Care & Maintenance
Ocean Comfort products are constructed from HDPE (High Density Polyethelene),
primarily a recycled material. UV inhibitors are also added to resist fading. Simply
maintain your furniture by cleaning with soap and warm water to ensure its long lasting
beauty. A soft bristle brush can be used on any tough to clean stains. Stainless steel
hardware is used in the assembly of these products and should be rinsed regularly with
fresh water if being used in a coastal environment.
KETTLER Limited Warranty
Ocean Comfort products are guaranteed for a period of 20 years (for residential use) and 5
years (for commercial use), starting from original purchase date. This warranty covers defects in
materials and/or workmanship and does not apply to the hardware.
Warranty not applicable to any products deemed as misused, abused or damaged due to an
uncontrollable act of nature.
*For Parts and Service, please contact us directly at 866-804-0440 or email [email protected]
Made in the U.S.A.