Kettler 2852 Installation guide

2852 52” ROUND DINING TABLE
Contents:
(4) Legs
(2) Side Braces
(2) Table feet
(1) Table Top
(16) 1/4 - 20 x 2 1/2” Bolts
(4) 1/4 - 20 x 3” Bolts
Tool Required:
#3 Phillips Head Screwdriver
Assembly Instructions
1. With the curved side facing out
align the table leg with the predrilled
hole on the foot of the table and insert a
1/4 - 20 x 3” bolt then tighten with the
phillips screwdriver.
Repeat on the other end, do both sets.
1.
Align the predrilled holes on the leg
with the metal insert on the frame,
insert the bolt.
3.
3. Place the side support
braces vertically between the
legs aligning the predrilled holes.
Insert a 1/4-20 x 2 1/2” bolt thru
the hole into the center brace
then tighten it with the phillips
screwdriver.
Repeat on the other brace, do both sides.
2. Place the leg with foot
inside the frame underneath the
tabletop. Align the predrilled
holes, insert two 1/4 - 20 x 2 1/2”
bolts then tighten them with the
phillips screwdriver.
Repeat on the other leg, do both sides.
2.
Made in the U.S.A.
www.kettlerusa.com
[email protected]
Copyright © Kettler USA 309.01

KETTLER® International Inc. • 1355 London Bridge Road • Virginia Beach, VA 23453
www.kettlerusa.com • [email protected]
Care & Maintenance
Ocean Comfort products are constructed from HDPE (High Density Polyethelene),
primarily a recycled material. UV inhibitors are also added to resist fading. Simply
maintain your furniture by cleaning with soap and warm water to ensure its long lasting
beauty. A soft bristle brush can be used on any tough to clean stains. Stainless steel
hardware is used in the assembly of these products and should be rinsed regularly with
fresh water if being used in a coastal environment.
KETTLER Limited Warranty
Ocean Comfort products are guaranteed for a period of 20 years (for residential use) and 5
years (for commercial use), starting from original purchase date. This warranty covers defects in
materials and/or workmanship and does not apply to the hardware.
Warranty not applicable to any products deemed as misused, abused or damaged due to an
uncontrollable act of nature.
*For Parts and Service, please contact us directly at 866-804-0440 or email [email protected]
Made in the U.S.A.