Keurig K4000 Service manual

Keurig K4000 Café System—Daily Cleaning Tasks
Daily — Quick Clean
Perform daily for optimal performance
1. Place an empty 12oz cup on the drip tray
2. Select "Quick Clean" from the main menu
3. Choose Brew Line Wash
4. Repeat steps, but choose
Soluble Line Wash
Turn off the brewer. Remove the nozzle cover housing by sliding it forward out of the holder (A). Pull down to
remove the milk nozzle (B). Uncap the milk nozzle for cleaning and sanitizing (C).
To reinstall, replace the milk nozzle, and slide the cover housing back into its holder.
Daily — Removing Milk Nozzle for Cleaning & Sanitization
Weekly — Removing the Mixing Bowl and Powder Hoppers
A B C
Lift the hopper cover. Start by rotating spouts on the powder hoppers to the horizontal position (1). Push
forward then lift up the powder hoppers (2). Next, disconnect the milk tube from the front of the mixing bowl
(3) and unlock the mixing bowl by turning the green tab to the right (4). Pull out the mixing bowl. Set aside
the mixing bowl and empty powder hoppers for cleaning and sanitizing.
To reinstall, reassemble the mixing bowl parts and slide the assembled bowl back into its original position.
Lock the mixing bowl by rotating the green tab all the way to the left. Reconnect the milk tube to the mixing
bowl by pushing the milk tube about ½’’ onto its connector. Replace the powder hoppers. Close the hopper
cover.
1 2 3 4
Turn over for Cleaning & Sanitization instructions →

Keurig K4000 Café System—Cleaning & Sanitization
Step 1. CLEAN
Urnex Rinza Alkaline Milk Frother Cleaner
Item # RIN-MFSSC1
Step 2. SANITIZE
Urnex Complete Café Equipment Sanitizer
Item # URN-CC1
1. PREPARE
Prepare diluted solution of Rinza,
Mix well and use immediately.
1. PREPARE
Prepare diluted solution of
Complete Café. Mix well and use
immediately.
15oz Rinza
Concentrate
2 Gallons Warm
Tap Water
+0.5oz Complete
Café Concentrate
2 Gallons Warm
Tap Water
+
Cleaning & Sanitization (recommended weekly)
Applicable items include: K-Cup bin, drip tray, mixing bowl, hoppers and nozzle.
2. SOAK FOR 30 MINUTES
Soak parts in Rinza solution for
30 minutes. If parts cannot be
removed, then dab a soft cloth into
the Rinza solution and use it to coat
appliance part.
2. SOAK FOR 1 MINUTE
Soak parts in Complete Café
solution for 1 minute. If parts cannot
be removed, then dab a soft cloth
into the Complete Café solution
and use it to coat appliance part.
3. RINSE
Remove parts from solution
and rinse well using tap water
to remove cleaning residue. If
parts were not removed from the
appliance, wipe well with a soft
cloth dipped in tap water.
3. DRY
Remove parts from solution
and allow to drain well and dry
completely. If the parts are not
completely dry, dampness can
lead to mold. Do not rinse. If
parts were not removed from the
appliance, wipe with a soft cloth
and let air dry.
AAA Business Supplies & Interiors may charge for service calls due to a
failure to properly maintain, clean and sanitize the brewer.
If you have any questions, please email [email protected] or call 800-821-4430.