Keyestudio GAMEPI KS0474 User manual

Component List
NO.
Specification
QTY
Picture
1
GAMEPI game console learning board
1
2
A24 Red Button
2
3
A24 Yellow Button
2
4
A24 Blue Button
2
5
M2*6MM round-head screws
4
6
M2*10MM round-head screws
4
7
M2.0*11MM dual-pass copper pillars
4
8
White Insulating column ABS
4

9
2pcs Arduino game console acrylic shells
1
10
3*83MM black screwdriver
1
11
M/mini5P clear blue OD:5.0 L=50cm eco-friendly USB cable
1
Installation
(1) Take out all the parts and put them together to install easily.
(2) Fix the GAMEPI game board and acrylic top board together with 4 M2*10MM round-head
screws, 4 white insulating column, and 4 M2.0*11MM dual-pass copper pillars.

(3) Install 6 button caps on the GAMEPI game console learning board.
(4) Fix the bottom acrylic board and the four M2.0*11MM dual-pass copper pillars together with 4
M2*6MM round-head screws.
Special Note: The holes of acrylic bottom board should be aligned with the potentiometer
on the GAMEPI game console when installed.

Getting started with the game console
After successful installation, we can upload the game program to the game console. Before
uploading the program, we need to install the driver for the game console first.
Installing the driver
Connect the game console to the computer with a USB cable. When the computer detects the
hardware, we open the device manager, as shown below.

B. Double click on driver file, click “next step”, driver starts installing automatically.
C. Install the driver successfully open the device manager, as shown below.

Downloading game program
After installing the driver successfully, we can start uploading the game program on the game
console. You can write game program by yourself, or use the game programs we provide. And
the program searched in Arduboy also can be used too.
More info about links of game program you could refer to: https://arduboy.ried.cl/
When installing click , as shown below.
The default name with symbols can’t be used, otherwise an error will occur, we need to rename
the game program with letters and numbers. After setting well, click “Download” to start
downloading the game program.
Uploading game program
When everything is ready, we can start uploading the game program on the game console.
A. Open the software as shown below:
B. Connect the game console to the computer with a USB cable, then click on the area that
arrow points to and select the game you want to download, choose the chip model (choose

Arduino leonardo).
C. Press reset button on game machine, the COM port will change briefly, click the area arrow
points to and set COM port. You’ll find that com1 changes into com4, as shown below!

D. Setting successfully, click and start uploading game program.
E. Installing game successfully, as shown below.