Keysight Technologies N7015A User manual

N7015A Type-C High Speed Test Fixture Kit
Quick Start and Accessories Guide
N7015A Kit
Standard
Contents
Wrench
(8710-2803)
Type-C High
Speed Test Fixture
Other Keysight Type-C Product(s) for use with N7015A
(sold separately)
N7018A Type-C
Test Controller
Detailed information on how to use N7015A and N7018A is available in the Keysight USB Type-C Connectivity Solution
User’s Guide. You can download this guide from www.keysight.com/find/N7015A.
If you are using N7015A with N7018A
Download the Keysight N7018A Type-C Test Controller software from www.keysight.com/find/N7018A and install it on
the host computer to be used for the connection setup.

© Keysight Technologies 2020
N7015-92003, January 2020
Connection Steps
Connect N7015A to N7018A
using the N7015A Type-C
interface cable. Keep the red dot
on the cable facing up to ensure
proper signal identification.
Connect the 2.92 mm connectors
of the N7015A to channel 1 and 3
of the Infiniium oscilloscope using
the supplied wrench and an
8”-lb torque wrench (8710-1765).
Connect the N7015A
to the Device Under Test.
N7015A TYPE-C TEST FIXTURE SETUP
*N7015-92003*
N7015A setup with
N7018A Type-C Test Controller
For more information: Visit http://www.keysight.com/find/N7015A
CAUTION: Minimize twisting the N7015A cables while connecting these to the oscilloscope or the N7018A test fixture.
Power on the N7018A
fixture by connecting it to
the Infiniium Oscilloscope
using the supplied
USB cable.
2
13
4