Kichler Lighting DC7206 User manual

User’s Manual
DC7206-remote control
General：
The remote is wholly used for matching brushless DC no sensor DC-18 ceiling fans
use. LCD, 3 V battery-powered, simple operation, stable performance, reliable
quality.
Type：
Type：DC-7206。
Main function：
Used for matching DC brushless no-sensor DC-18 use, through nine keys on the
remote, it is easy to operate after opening the back of the battery cover to install
battery.
Structure chart：
See attached fig1.：
1 、Start key 1;
2 、Start key 2;
3 、Start key 3;
4 、Start key 4；
5 、Start key 5；
6 、Forward/ reverse control key；
7 、Power off；
8 、Up lamp :Power off /on ;
9 、Down lamp :Power off /on;
10、6 V battery.
Specifications:
1, the working voltage: DC-6V;
2, static current: less than 20 uA;
3, working current: less than 20 mA;
4, effective assorting space with the receiver in the same series: not less than 12
meters;
Instruction：
1、Start key 1：Pressure the key,DC-18 start at the first gear;
2、Start key 2：Pressure the key,DC-18 start at the second gear;
3、Start key 3：Pressure the key,DC-18 start at the third gear;

4、Start key 4：Pressure the key,DC-18 start at the fourth gear;
5、Start key 5：Pressure the key,DC-18 start at the fifth gear;
6、“ ”Forward/ reverse control key：Pressure the key，the fan can switch at
Forward or Reverse rotatiom；
7、“ ”Power off: Pressure the key，the fan stop;
8、“ ” Up lamp :Power off /on: Pressure the key,the Up lamp power on at the
first time ,then pressure it again,the UP lamp power off.and the rest may be deduced
by analogy;
9、“ ” Down lamp :Power off /on: Pressure the key,the Down lamp power on at
the first time ,then pressure it again,the Down lamp power off.and the rest may be
deduced by analogy;
Remark: changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
All other devices shall bear the following statement in a conspicuous location
on the device:This device complies with Part 15 of the FCC Rules. Operation
issubject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation。

attached fig1:
7
6 . 0 V B a t t e r y
6.0V
10
9
8
65
4
3
2
1
DC-7206
I
T
H
I
G
L
G
N
R
E
H
I
C
L
K
5
4
3
2
1