
Install the brackets to the instrument in the next procedure and build in it to the rack.
1. Remove the rubber feet on the bottom panel.
2. As shown in figure, using 5screws, install 1and 2brackets.
For 5screws, do not use except the accompanying screws (M4 x 8 Double
sems bind screws).
Install 3rails with 6screws. For 6screws, do not use except the
accompanying screws (M4 x 8 flat head screws).
Be careful with the orientation that the 3rail should be installed.
3. Using 4screws and 7washers, mount the instrument in the rack.
KRB150-PLZ-30F
INSTRUCTION MANUAL
Bracket
KIKUSUI ELECTRONICS CORP.
1-1-3, Higashiyamata, Tsuzuki-ku, Yokohama, 244-0023, Japan
The surface with the flat
head screw holes is bottom
side of the 3rail.
3
1
2
5
1
5
33
6
6
6
47
7
4
CODE DESCRIPTION QTY
No.
1 B9-000-043 BRKT KRB150-PLZ-30F L/ R 2
2 B9-000-045 BRKT KRB150-PLZ-30F TOP 1
3 E1-000-011 RAIL PLZ-30F 2
4 M2-102-002 OVH SCREW S-NI M5X0.8X14 4
5 M3-112-026 DBL SEMS K-MARU PNH SCR S-NI M4X0.7X8 6
6 M2-101-015 FLH SCREW S-NI M4X0.7X8 4
7 M5-003-031 CUP WASHER 5 CW 4
The instrument may fall.
Install the suitable support angles
applying to the used rack system to
support the instrument.
Support angle
Imstrument
CAUTION