
Assembly Ins ruc ions
Footprint®
Proper product installation, in accordance with these instructions, is the responsibilit of the installing agent.
If ou have an questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 1847185 Revision D-09
Page 1 of 2
Worksurface Cantilever Bracket
for Interworks®E Panel
Tools Required
■Drill with Torque Option ■Tape Measure
■#R-2 Square Srewdriver Bit ■Level
■Rubber Mallet
Package Con en s
■#8 x .75 Robinson Head Flakeboard Screw
General Informa ion
■Cantilevers are required when placing two surfaces end to
end, when open kneespaces are greater than 48" for 1 3/16"
surfaces or 60" for 1 9/16" surfaces, or in configurations
where standard panel worksurface bracket support is not
possible. Cantilevers are designed so that a single bracket
can share the load between two adjacent surfaces. They
can be used as sole support for a worksurface. The top of
the cantilever should be located 24" from the bottom of
fabric for standard height (29" nominal). (Figure A).
Ins alla ion
1. Insert hook on the top of cantilever into the slot on panel
siderail at a 45˚ angle. (Figure B).
2. Push the top of the cantilever downward. (Figure C).
Important: Use mallet to make sure bracket is seated and
fully engaged.
Figure A
Standard
Height
24"
45˚
Figure B
Figure C
1
2