King Industrial SS-8377 User manual

INST UCTION MANUAL
COPY IGHT © 2017 ALL IGHTS ESE VED BY KING CANADA TOOLS INC.
MODEL: SS-8377
MITER STAND FOR
METAL CUTTING BANDSAW
Designed to fit King
Metal Cutting
Bandsaw model
KC-8377
07/2017
WA ANTY INFO MATION
2- EAR
LIMITED WA ANTY
FO THIS MITE STAND
KING CANADA TOOLS
OFFE S A 2-YEA LIMITED WA ANTY
FO NON COMME CIAL USE.
PROOF OF PURCHASE
Please keep your dated proof of purchase for warranty and servicing purposes.
LIMITED TOOL WARRANT
King Canada makes every effort to ensure that this product meets high quality and
durability standards. King Canada warrants to the original retail consumer a 2-year
limited warranty as of the date the product was purchased at retail and that each
product is free from defects in materials. Warranty does not apply to defects due
directly or indirectly to misuse, abuse, normal wear and tear, negligence or
accidents, repairs done by an unauthorized service center, alterations and lack of
maintenance. King Canada shall in no event be liable for death, injuries to persons
or property or for incidental, special or consequential damages arising from the use
of our products.
To take advantage of this limited warranty, return the product at your expense
together with your dated proof of purshase to an authorized King Canada service
center. Contact your retailer or visit our web site at www.kingcanada.com for an
updated listing of our authorized service centers. In cooperation with our authorized
serviced center, King Canada will either repair or replace the product if any part or
parts covered under this warranty which examination proves to be defective in
workmanship or material during the warranty period.
NOTE TO USER
This instruction manual is meant to serve as a guide only. Specifications and
references are subject to change without prior notice.
KING CANADA INC. DORVAL, QUÉBEC, CANADA H9P 2 4
www.kingcanada.com

ASSEMBLY & OPE ATION
WARNING! ead and follow all safety rules in the
Metal Cutting Bandsaw manual before operating
your Bandsaw on this Miter Stand.
ASSEMBL
Installing fixing block
1. First step is to install the fixing block (A) Fig.1
to the Bandsaw body with the provided pan
head screws (B) using a screwdriver.
2. Mount the Bandsaw to the Miter Stand arm (A)
Fig.2 with three cap screws and spring
washers (B) using a hex. key.
OPERATION
Fixing workpiece in quick lock vise
1. Pivot the vise lock handle (A) Fig.3 clockwise
to release the moveable vise jaw & shaft (B).
2. Pull the vise jaw & shaft (B) assembly towards
the rear. Place workpiece between both jaws,
push vise jaw & shaft (B) assembly up against
the workpiece.
3. Pivot the vise lock handle (A) Fig.3 counter-
clockwise to secure the workpiece and the
moveable vise jaw & shaft (B).
FIGURE 1
FIGURE 2
FIGURE 3
Making miter cuts
1. To make any angled cut between 00- 450, first
loosen the lock handle (A) Fig.4.
2. Pivot the bandsaw and miter base (B) Fig.4 to
the desired angle using the indicator and angle
scale (C) as a guide.
3. etighten lock handle (A).
Adjusting the resistance of the arm
1. If the resistance of the arm is too loose (falls)
or too tight (hard to move), the tightness of the
acorn nut (C) Fig.2 can be adjusted to suit your
needs.
FIGURE 4
OPE ATION