Kirby Morgan KM 37 User manual

Kirby Morgan Dive Systems, Inc.®
1430 Jason Way Santa Maria, California 93455
Phone: [phone] Fax: [phone]
www.KirbyMorgan.com email: [email protected]
K
I
R
B
Y
M
O
R
G
A
N
D
I
V
E
S
Y
S
T
E
M
S
,
I
n
c
.
© MMXVIII Kirby Morgan Dive Systems, Inc. All Rights Reserved Document #180905001 Page 1 of 2
Part #525-717
KM 37, 47, 57 and SL 17K Brackets Kit
PART NUMBER DESCRIPTION QTY
530-040 Screw 2
530-043 Screw 3
530-556 Washer 1
540-130 Mount Bracket—Port Side 1
540-132 Mount Bracket—Starboard Side 1
Mount Bracket Installation
1) Remove the two port retainer screws, one on either
side of the handle. These will not be reused to mount
the brackets.
2) To install the mount brackets P/N 540-130 & 540-132, the handle must be removed as described in the
Operations and Maintenance manual Accessories module. Remove the two bracket mount screws and
washers from the top weight. These will be reused to mount the brackets.
3) Position the two brackets on the helmet and reinstall the two bracket mount screws and washers that go
into the top weight. DO NOT TIGHTEN.
4) Align the holes in the front part of the brackets
with the holes in the port retainer. Install one screw
in each bracket in the outer mount holes. (Screw P/N
530-040 supplied in the kit) DO NOT TIGHTEN.

Kirby Morgan Dive Systems, Inc.®
1430 Jason Way Santa Maria, California 93455
Phone: [phone] Fax: [phone]
www.KirbyMorgan.com email: [email protected]
K
I
R
B
Y
M
O
R
G
A
N
D
I
V
E
S
Y
S
T
E
M
S
,
I
n
c
.
© MMXVIII Kirby Morgan Dive Systems, Inc. All Rights Reserved Document #180905001 Page 2 of 2
530-043
530-040
530-556
5) Position the handle on the helmet and
align all the holes. Install new screws P/N 530-
043. First install the 2 outer screws, but DO
NOT TIGHTEN. Slide the washer P/N 530-556
between the handle and the port retainer and
install the center handle screw through the
washer. DO NOT TIGHTEN.
6) Thread the rear handle mount screw and washer
into the top weight. DO NOT TIGHTEN.
7) Tighten screws. Torque the front handle and the bracket mount screws
first. Torque to 12 inch pounds.
DO NOT OVERTIGHTEN SCREWS!
Over torquing these screws can cause severe damage to the helmet shell
and the port retainer threaded inserts. Always use a torque screwdriver to
tighten any port retainer screws.
8) Torque the handle and accessory mounting screws on the top weight to
35 inch pounds.