
(28508RC0608)
06/08 Printed in U.S.A.
KGRS205T
Range
®Registered trademark/™Trademark of KitchenAid, U.S.A.
©2008. All rights reserved.
KitchenAid • Benton Harbor, Michigan 49022 U.S.A.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
For additional information about KitchenAid®appliances, visit KitchenAid.com
or call the Customer Experience Center at 800-422-1230. We’ll help you select
the ideal model, answer questions about appliance operation and performance,
and give you a point of contact should you ever need service.
Freestanding Gas
PRODUCT DIMENSIONS CUTOUT DIMENSIONS
29"
Model/serial
number plate (located behind
the storage drawer on the left-hand
side of the oven frame)
Rating number plate (located
behind the storage drawer on the
right-hand side of the oven frame)
297/8"
*Range can be raised approximately 1" by adjusting the leveling legs.
355/8"*
471/8"*
263/4"
depth to
backguard
standoffs
Anti-tip bracket:
To install the anti-tip bracket
shipped with the range,
see Installation Instructions.
H
Cabinet opening dimensions shown are for 25" countertop depth,
24" base cabinet depth, and 36" countertop height.
Note: 24" minimum when bottom of wood or metal
cabinet is protected by not less than 1/4" flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" stainless steel, 0.024" aluminum or 0.020" copper.
30" minimum clearance between the top of the cooking
platform and the bottom of an unprotected wood or metal cabinet.
If installing a hood or microwave hood combination above the
range, follow hood or microwave hood combination installation
instructions for dimensional clearances above the cooktop surface.
*
30" min.
opening width
3"
6"
6"
13" max.
upper cabinet depth
For minimum
clearance to
top of cooktop,
see Note.*
31/4"
31/4"
3"
3"
6"
19"
18"
upper cabinet
to countertop 30" min.
opening width
Shaded area
recommended
for installation
of rigid gas pipe.
Cabinet door or
hinge should not
extend into the cutout.
H
Cabinet opening dimensions shown are for 25" countertop depth,
24" base cabinet depth, and 36" countertop height.
Note: 24" minimum when bottom of wood or metal
cabinet is protected by not less than 1/4" flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" stainless steel, 0.024" aluminum or 0.020" copper.
30" minimum clearance between the top of the cooking
platform and the bottom of an unprotected wood or metal cabinet.
If installing a hood or microwave hood combination above the
range, follow hood or microwave hood combination installation
instructions for dimensional clearances above the cooktop surface.
*
30" min.
opening width
3"
6"
6"
13" max.
upper cabinet depth
For minimum
clearance to
top of cooktop,
see Note.*
31/4"
31/4"
3"
3"
6"
19"
18"
upper cabinet
to countertop 30" min.
opening width
Shaded area
recommended
for installation
of rigid gas pipe.
Cabinet door or
hinge should not
extend into the cutout.