---Switch on Obsess 7 by pushing on No.2 (see the drawing)
---Switch off Obsess 7 by pushing on No.1.
---Touching No.3 and 4, change the color saturation. Push on No.3 to increase, No.4 to
decrease the color.
Push on No.4 button for seconds, the light gradually change to white balance( normal
light )
---Touching No.5. you can move your finger over the color
ring, to select the colors. ---Touching No.6 to
brighten the light ---Touching
No.7 to dim the light ---No.8 is
the indicator. It
will twinkle when
operate the
lamp, which
means effective operation.
1. Gradual Change Mode
--Under powered condition, press No.2 button, obsess 7 will be changed into gradual change mode. Touch A/B button,(show as
below) you can control the speed of gradual change, A to speed, B to low down. Changing them into normal mode need to close
the Obsess 7 and restart it.
2. Hopping mode:
-Under gradual change mode condition, touch No.2 button,the Obsess 7 will be changed to hopping mode. Touch A/B button can
control the speed of it. A to speed, B to slowdown. Changing them to normal mode need to restart the Obsess 7. 3. Pay attention:
The change of the above two presentation mode need 4 seconds.
Operation Instructions (Remote Control is Touching Button)
Touch ON/OFF button, you can switch on/off the RGB strip.
Slide the color ring, RGB strip will show the same color.
Increasing color button can adjust the current color to the most vivid, decreasing color button is contrary, until pure white.
You can adjust the brightness by dimming function, to brighten and dim the light.
Gradual change mode: Touch on button again under monochrome mode condition, RGB strip will be changed into gradual
change mode. Increasing color button will speed up the color change, decreasing color button will slowdown.