Knightsbridge LEDFWIFI User manual

Hey Google
works with

These instructions should be read carefully and retained after installation by the
end user for future reference and maintenance.
These instructions should be used to aid installation of the following product:
LEDFWIFI
• This product must be installed in accordance with the latest edition of the IEE
Wiring Regulations (BS7671) and current Building Regulations. If in any doubt,
consult a qualified electrician
• Please isolate mains prior to installation or maintenance
• Please note the IP (Ingress Protection) rating of this product when deciding the
location for installation
• This product is Class III
• This product is IP20 rated

When using RGBW LED Flex,
terminate the cables to the
LEDFWIFI: Black to V+, Blue
to B, Green to G, Red to R
and White to CW (see Fig. 2)
Please note: this product does not work with dimmable drivers.
• Provide power to the required point of installation
• With the aid of a flat-head screwdriver, insert into access slots on the rear of the
controller then carefully push to remove the cover to access the terminals
(see Fig. 1)

• When using RGB LED Flex, terminate the wires to the LEDFWIFI: Black to V+,
Blue to B, Green to G and Red to CW. Please note that the Red wire must be
inserted into the CW terminal just for the paring procedure. After the pairing
procedure is finished, please insert the Red wire into the R terminal
• When using CCT LED Flex, terminate the wires to the LEDFWIFI: Red to V+,
Yellow to WW and White to CW
• When using Cool White or Daylight LED flex, terminate the wires to the
LEDFWIFI: Red to V+ and Black to CW. When using Warm White LED flex,
terminate the wires to the LEDFWIFI: Red to V+ and Black to CW for the pairing
procedure; once the pairing procedure is finished, insert the Black wire into the
WW terminal
• Refit the terminal cover
• Switch on and check for correct operation
This product must be disconnected from the circuit if subjected to any high voltage
or insulation resistance testing. Irreparable damage will occur if this instruction is
not followed.
This product should be recycled in the correct manner when it reaches the end of
its life. Check local authorities for where facilities exist.
This product is dimmable via app only.

This product has a warranty of 2 years from date of purchase. Failure to install
this product in accordance with the current edition of the IEE Wiring Regulations
(BS7671), improper use, or removal of the batch code will invalidate the warranty.
If this product should fail within its warranty period, it should be returned to the
place of purchase for a free of charge replacement. ML Accessories does not accept
responsibility for any installation costs associated with the replacement product. Your
statutory rights are not affected. ML Accessories reserve the right to alter product
specification without prior notice.

• Download the SmartKnight app from Google Play Store of the Apple App
Store
• Once the app is downloaded, open the app and tap “Register” then follow
the on-screen instructions
• To add a luminaire to the app, switch on the power and tap “+” on the top
right corner
• Select “Lighting (Wi-Fi)”
• If the light is flashing rapidly, skip the reset procedure and tap “Confirm
the light is flashing rapidly”. If the light is not flashing, follow the on-screen
instructions to reset it
• Connect to the desired Wi-Fi network, tap “Confirm” and the app will start
searching for devices. Please note that only 2.4GHz networks are supported
and make sure that your device is connected to the same Wi-Fi network
• After the light has been added successfully to the app, the luminaire can be
named and added to a room. After naming the luminaire, tap “Done”

ML Accessories Limited LU5 4LT
www.mlaccessories.co.uk
118
INTERNATIONAL
CONTACT DETAILS
INTERNATIONAL
CONTACT DETAILS
INTERNATIONAL
CONTACT DETAILS
AVJUN21_V3