Knightsbridge SK006 Instruction Manual

IP54 13A 3G POP UP SOCKET
11
230V
50Hz
IP
54
INSTALLATION & MAINTENANCE MANUAL
SK006

• Installation of this product should only be carried out by a qualified electrician or competent person
to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this product is fitted) does not exceed the rating
of the circuit cable, fuse or circuit breaker
• This product is Class I and requires an earth
• This product is IP54 rated (only when the product is in the closed position with no appliances
attached)
• Provide power to the required point of installation
• Locate a suitable place to mount the product. We recommend a surface thickness of min 10mm to
max 50mm
• Cut a 90mm hole in the surface, allowing a 25mm clearance around the hole (see Fig 1)
• Note: ensure there is sufficient space beneath the surface when the product is in the closed
position
SAFETY
INSTALLATION
CONTENTS
These instructions should be read carefully and retained after installation by the end user for future
reference and maintenance.
These instructions should be used to aid installation of the following product:
SK006
90mm
25mm
Fig 1

• Remove the mounting collar and rubber gasket, by rotating anti-clockwise
• Insert the product through the hole
• Put product in desired orientation and insert rubber gasket to bottom. Tighten the mounting collar
to the underside of the surface (see Fig 2)
• To raise the product, gently lift the handle on the top cover. Raise until it clicks, this means its
locked in position (see Fig 3a)
• To lower the product press the release button (see Fig 3b)
• Connect to mains supply via the pre-wired cable and plug
OPERATION
Lift the handle and
pull product up
Fig 2
Fig 3a Fig 3b

ML Accessories Limited
LU5 5TA
www.mlaccessories.co.uk 09-14 V1 – BT
• Always use the handle to raise/lower product (see Fig 4)
This product must be disconnected from the circuit if subjected to any high voltage or insulation
resistance testing. Irreparable damage will occur if this instruction is not followed
The fitting should be recycled in the correct manner when it reaches the end of its life. Check local
authorities for where facilities exist.
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may
damage the fitting.
This product has a warranty of 1 year from date of purchase. Failure to install this product in
accordance with the current edition of the IEE Wiring Regulations, improper use, or removal of
the batch codes will invalidate the warranty. If this product should fail within its warranty period it
should be returned to the place of purchase for a free of charge replacement. ML Accessories does
not accept responsibility for any installation costs associated with the replacement product. Your
statutory rights are not affected. ML Accessories reserve the right to alter product specification
without prior notice.
WARNING
GENERAL
WARRANTY