Knox KEYDEFENDER KD-MB-R5 User manual

With three mounting sizes available, the KeyDefender can be installed in multiple locations within the vehicle
using the RAM®mount system. RAM® mounts have an adjustable arm with 2 adjustable bases on the top
and bottom. The handle can be rotated to loosen the bases and then tightened to lock the bases into the
preferred position.
Included are security fasteners to mount the KeyDefender to the RAM® mount. Fasteners are not included
to mount the RAM® bracket to the vehicle interior. Customers are responsible for determining an adequate
mounting location and securing the RAM® Mount to the interior of the car. The maximum fastener length into
the back of the KeyDefender is 5/8”.
KNOX KEYDEFENDER™
MOUNTING INSTRUCTIONS
OPE-ESYSLR-0551-C
1601 W. DEER VALLEY RD. PHOENIX, AZ 85027 | T. 800-552-5669 | F. 623-687-2290 | [e-mail] | KNOXBOX.COM
©Knox Company. All rights reserved. RAM® is a registered trademark of National Products Inc.
KNOX PART NUMBER DESCRIPTION
KD-MB-R5 KeyDefender Mounting Bracket 5”
KD-MB-R7 KeyDefender Mounting Bracket 7”
KD-MB-R11 KeyDefender Mounting Bracket 11”
KeyDefender Mounting Instructions
Included in all Knox RAM® Mount Packages
• RAM® Mount (one of 3 dierent sizes)
• RAM® Pin-Lock™ 5-Pin Security Knob
• 4 Security fasteners 8-32 3/8”
• Tamper Resistant T15 Torx Bit 1/4” hex shank
RAM® Mount Sizes

OPE-ESYSLR-0551-C
1601 W. DEER VALLEY RD. PHOENIX, AZ 85027 | T. 800-552-5669 | F. 623-687-2290 | [e-mail] | KNOXBOX.COM
©Knox Company. All rights reserved. RAM® is a registered trademark of National Products Inc.
Security Knob
A Security Knob is shipped with each RAM® Mount package purchased from Knox. The standard handle can
be loosened and the KeyDefender can then be removed. The Security Knob prevents theft by replacing the
standard handle with a knob and knob key system. Once the Security Knob is installed, it cannot be loosened
without using the knob key (pictured below). The Knox Company recommends installation of the security knob.
Assembling the RAM® mount
No tools are required for assembling the RAM® Mount.
PLEASE NOTE: A socket screwdriver is required to install the KeyDefender to the RAM® mount base.
DIRECTIONS
Replacing the Standard Knob with Security Knob
1. Unpack all components
2. Replace the standard T-Handle with the security knob
3. Hold the socket arm assembly vertically upright while removing the T-handle
4. To remove the T-handle, rotate the handle counterclockwise. When removing the handle, please note there
are two washers on the screw connected to the handle
5. Once the T-Handle is removed, place the security knob on the screw. It may be necessary to squeeze the
arm (compress spring) to attach security knob to the screw threads
Mount KeyDefender to RAM® Mount
• Use the supplied 4 security fasteners and the security bit to mount the KeyDefender to one of the RAM®
mount bases
Assemble Bases
1. Loosen the RAM® Mount by using the knob key to rotate the security knob counterclockwise
2. Place bases into the socket arm assembly
3. Adjust the bases to desired location and use the knob key to tighten the socket arm assembly by
rotating clockwise
Mounting KeyDefender in Vehicle
• Locate the best possible location for installing the KeyDefender
• Fasteners are not included to mount the RAM® Mount system to the car interior.
KNOX KEYDEFENDER™
MOUNTING INSTRUCTIONS