Kobelt 7175 Operating instructions

Please visit our website www.kobelt.com for more information.
05/2008
Model 7175
Rudder Angle Indicator
The 7175 rudder indicator system will
continuously monitor and indicate the position
of your rudder.
Whether you are manœuvring, power steering
or changing course, an accurate readout of the
rudder position will be displayed on a tri-
coloured three-inch display.
A basic system will consist of a 7175-MY
Master station indicator and a Kobelt 7168
Feedback Unit for signal input.
Up to five additional “repeater stations” can be
installed using the 7175-SY repeater.
Both the master and repeater have a backlit
translucent display with an optional dimmer and
are waterproof on the front face.
All Dimensions in inches (mm)
Approx. weight: 1 lb (0.5 kg)
3.8
(96)
0.38
(9.5)
2.04
(52)
Tel.: +49 (0)40 - 88 90 100
www.toplicht.de
Schisausrüster

05/2008
TROUBLESHOOTING
Problem Action
Indicator(s) not operational
Master indicator moves in opposite
direction to rudder
Secondary indicator moves in opposite
direction to rudder
Port and Starboard hardover to hardover
are not equal
Indicator(s) movement not in sequence
with rudder movement
Check for proper wiring and fuse
Reverse wires V+ and V- at respective
terminals
Reverse wires as above
Rudder angle feedback unit 7174 / 7168 not
installed or adjusted properly
Calibrate linkage to obtain desired stroke /
calibrate span
NOTES:
Damage to the Rudder Indicator may occur if input voltage is reversed.
Additional stations, if any, are to be connected in series as in figure 3.
In-line fuse (2A) or a breaker from the power source is recommended.
Match lamp voltage to power supply voltage
Lamp provided is of 12 VDC. (A 24 VDC is available as spare)
Zero adjust will allow ±1 degree of adjustment