Kodak 8461444 - Max Flash Camera One Time Use User manual

CIS-256
June 2004
•Make sure “0” is aligned with the arrow in the
frame-counterwindow.
•If the “0” is not aligned, grip the camera and
cover the lens.Then press the shutter button
and turn the thumbwheel (repeat these steps
until the film is fully rewound).
The film is fully rewound when the thumb-
wheel rotates freely and does not stop or lock.
•Insert the special tool into the end slot.
•Using the special tool, hold the camera firmly
and pull upwards to break off the film door
and to remove the film.
• Place the used camera in the
Kodak recycle bin.
• Visit our Web site at http://
www.kodak.com/go/kes for details
aboutKodak’srecycling program.
• Call Kodak’s advertising distribution
centerat(800)847-8755 to order
aKodakhand-openingtool.
CAUTION:Beforeyouattempt the
opening tasks, make sure the tool is
fully engaged with the camera body to
prevent tool slippage.
CAUTION:This camera body contains
a high-voltage capacitor and circuit
board.To avoid electric shock,do not
pry apart the front and back sections
of the camera. Remove only the film
from its respective compartment. If
sections of the camera are separated,
do not touch the circuit board.
©Eastman KodakCompany,2004
5
CURRENT INFORMATION SUMMARY
Opening Instructions for the
KODAK Zoom One-Time-Use Camera
Weareyeprotection when opening allcameras.
Wind Off
0
shutter button
thumbwheel
1Insert Tool
2
Break Off Film Door
3
Remove Film
Exposed
Film
Opened camera
with film removed.
4

Current Information Summaries provide information of limited or specific
application. Responsibility for judging the timeliness and applicability of the
information to a specific photographic use rests with the end user.
CIS-256, Opening Instructions for the
KODAK Zoom One-Time-Use Camera Kodak is a trademark. New 6-04
Consumer Imaging
EASTMAN KODAK COMPANY • ROCHESTER, NY 14650