Kodak CIS-169 Manual

CIS-169
April 1995
CURRENT INFORMATION SUMMARY
Opening Instructions for the
KODAK MAX Flash One-Time-Use Camera
Wear eye protection when opening all cameras.
Wind off
Open Film Door
Remove Film
©Eastman Kodak Company, 1996
1
2
3
4Remove Battery
5
• Check the frame counter window.
• X’s must be visible.
• If not, grip camera, press shutter button, and
turn thumbwheel untill film is fully rewound.
• Insert special tool into end slot (as shown).
• Use tool to bend cover back and remove film.
• Place in recycle bin.
• Return to Kodak for recycling.
• Repeat the same steps at opposite end of
camera to remove battery.
Battery
Opened Camera with film and battery removed.
Exposed Film
Shutter Button
Thumbwheel
CAUTION: This camera body
contains a high voltage capacitor
and circuit board. To avoid electric
shock, do not pry apart the front and
back sections of camera. Remove
only film and battery from their
respective compartments. If sections
of the camera are separated, do not
touch the circuit board.
CAUTION: To avoid injury, use tool
carefully.

Current Information Summaries provide information of limited or specific
application. Responsibility for judging the timeliness and applicability of the
information to a specific photographic use rests with the end user.
Consumer Imaging
EASTMAN KODAK COMPANY • ROCHESTER, NY 14650
Minor Revision 12-98
Printed in U.S.A.
Kodak and Max are trademarks.
CIS-169
Opening Instructions for the
KODAK MAX Flash
One-Time-Use Camera