Kogan KABTHDJBLKA User manual

KABTHDJBLKA
USER MANUAL

User Manual
What's in the Box.
1. Headphones
2. Micro USB Cable
3. 3.5mm audio cable
Please read carefully this manual before usin headphones, and keep a copy handy for
future reference.

Know your headphones:
1. To le switch - Three Direction – Three Functions
a. Move Upwards: Volume + / Previous track
b. Move Downwards: Volume - / Next track
c. Press it In: Pause / Play
2. Power button / Bluetooth power button
3. Micro USB slot
4. Line in slot
5. Mic
■pecification and Parameter:
Dimension ：200x170x75(mm)
Wei ht ：175 （bare headphone, without packa in ）
Char in interface： Micro USB
Press buttons： two （power button + to le switch ）
Battery ： 3.7V/250mAh
Char in specification：Micro USB
Char in input ： 5V/1.0A
Char in indication ： Solid Red LED li ht
Standby time ： about 100 hours
Successive talkin time： about 8 hours
Char in time: 2-3 hours
Volume control：16 ranks, 3dB variation in each rank
Workin temperature ： -20～70℃ durin the char in period
Stora e temperature： -40～80℃

■peaker parameter
Speaker diameter: Φ40mm
Impedance： Impedance: 32Ω
Sensitivity：S.P.L:110dB S.P.L.at 1KHz
Rated power: 20mW
Frequency Response: 100Hz-9000Hz
■Microphone parameter
Microphone Unit: Φ4*1.5mm
Directivity: Omni direction
S.P.L: -42±3dB
Impedance: ≤2.2KΩ
Frequency Response: 20-20,000HZ
Operatin volta e: 4.2V
■Bluetooth Mode:
Device Mode Number： BT513
Bluetooth Protocol version： CSR , Version 2.1+EDR
Remote control to the player： Volume up and down, Previous /Next, Pause/Play
Receiver ran e: 10m / 360°
Pairin code: 0000
SNR： -82dBm
Carrier frequency: 2402MHz - 2480MHz
Frequency response: 20Hz – 20,000Hz
Successive workin time: Approximately 8 hours
Standby time: Approximately 100 hours

■Operation
Turn ON： In the state of power-off, press and hold the power button for 1sec, the headset will
send out two “di-di” Prompt tones and blue LED will be on ; the blue and red LED li ht will
litters in turn if holdin power button for 4 sec.
Turn OFF ： In the state of power-on, press and hold power button for 3 seconds till the blue
LED li ht litters three times. There will be four "dodo” voices from loud to low. Now the unit
is turned off.
Pairing： In the state of power-off , press and hold power button for 3s until red and blue LED
li ht litters in turn, the headphone enters into pairin mode. In this case, the headset can be
paired with the Bluetooth enabled device.
※ Usually ，Setup procedure relates to the “setup”,” connection” or “Bluetooth” menu in your
mobile phone or Bluetooth device. Click “search for Bluetooth device”, your phone will find the
headphone name ”513” or similar pairin name and ask if you want to connect, then click
“confirm” or “yes”. Afterwards, input the pairin password or PIN code ”0000” and click ”yes” or
“confirm”, the headphone will connect with your Bluetooth device successfully.
※ The headphone will enter in power-on mode if releasin power button before red and blue
LED li ht litters in turn. In this case, please turn off the power and operate it once a ain.
Answering calls: Press the power button once to answer the incomin calls.
Dialing calls: If the headset is paired with the mobile phone, dialin the numbers on the cell
phone will enable the conversation on the headset automatically.
Ending calls: On oin conversation on cell phone can be ended by pressin the power key
once.
Redial latest number: The cell phone will automatically dial the last dialed phone number
by double pressin power key on the Bluetooth headset. We can hear the prompt tone from
the headset.
Volume control: In the state of music or calls, move to le switch upwards to increase the
sound and move it downwards to decrease the sound.
Previous /Next: Move the to le switch upwards and hold it for a short while to come to
previous son , then move the to le switch downwards and hold it for a short while to come to
next son .
Pause /Play: Press the to le switch button inside to pause or play the music.

■Wired headphone Function
The headphone can be used as the wired headphone. Just simply attach 3.5mm audio
cable.
In the state of power off: It can be used as the wired stereo headphone by insertin the
3.5mm audio cable. Please adjust the volume of sound sources when it is as the wired
headphone. In this case, the volume control of the headphone can' t be workable.
■ymbol of LED Light ：
Power on---Blue li ht is on.
Power off---No li ht.
Charging---Red li ht is on. No li ht is on when is fully char ed.
Power hortage---Red li ht flashes.
Pairing mode---Red and blue li hts flash in turn