Kogan FSDB24STNDB User manual

ADJUSTABLE SMARTBELL
STAND
FSDB24STNDB

Part
Description
Part
Description
1
Bottom cross brace
10
Nut (x20)
2
Rear left stabilizer
11
Flat washer (x36)
3
Rear right stabilizer
12
Screw 16x3 (x8)
4
Stand leg (x2)
13
Screw 16x2.75 (x4)
5
Left dumbbell platform
14
Screw 16x2.5 (x4)
6
Right dumbbell platform
15
Screw 16x1.0 (x4)
7
Towel bar
16
Casters (x4)
8
Foot pegs (x4)
17
Centre Plate
9
Straps (x2 pairs)
COMPONENTS

Hardware
Hardware Card A
Hardware Card B
QTY
Description
QTY
Description
4
2.75” Screw, button head
8
3.0” Screw, button head
4
2.5” Screw, button head
8
Lock nut
4
1.0” Screw, flat head
16
Flat washer
12
Lock nut
1
Allen key
20
Flat washer
Tools Required
Socket 9/16”
Wrench 9/16”
Utility Knife or Scissors

Step 1
Attach the rear left stabilizer (2) to the stand leg (4) using x2 screws (12), x2 nuts (10) and x4
flat washers (11).
Note: Do not fully tighten hardware.
ASSEMBLY

Step 2
Attach the rear right stabilizer (3) to the stand leg (4) using x2 screws (12), x2 nuts (10) and
x4 flat washers (11).
Note: Do not fully tighten hardware.

Step 3
Attach the bottom cross brace (1) to the rear left stabilizer (2) and the rear right stabilizer (3)
using x4 screws (12), x4 nuts (10) and x8 flat washers (11). Ensure the narrower edge of the
cross brace (1) is closer to the stand leg (4) uprights.
Note: Do not full tighten the hardware.

Step 4
Install the centre plate (17) to both stand legs (4) using x4 screws (14), x4 nuts (10) and x8
flat washers (11).
Note: Ensure the centre plate edges are on the outer sides of the legs and that the logo is
right side up. Tighten all hardware from steps 1-3 securely.

Step 5
Secure the left dumbbell platform (5) to the assembly using x2 screws (13) using x2 nuts (10)
and x4 flat washers (11).
Note: Ensure the screw holes in the platform are facing toward the inside of the stand.

Step 6
Secure the right dumbbell platform (5) to the assembly using x2 screws (13) using x2 nuts
(10) and x4 flat washers (11).
Note: Ensure the screw holes in the platform are facing toward the inside of the stand.

Step 7
Secure the towel bar (7) to the assembly using x4 screws (15) using x4 nuts (10) and x4 flat
washers (11).
Hand tighten the screws in a cross pattern to ensure an even fit.
Note: Tighten all fasteners securely.

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com