Kogan KATVBKSTNDA User manual

SWIVEL TABLETOP STAND
WITH GLASS BASE
FOR 32”-70” TVS
KATVBKSTNDA

Ensure to read all instructions before use and retain this user guide for future reference.
Note the following icon when lifting or moving this unit:
Lifting with two people is recommended at all times.
•Ensure you have located all components before
disposing of any packaging materials.
•This unit is for indoor use only. Use outdoors may result in
product failure, product damage and/or personal injury.
•This unit is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, unless they have
been given supervision or instructions concerning use of the appliance by a person
responsible for their safety.
•This unit contains small parts which could pose a choking hazard if swallowed. Keep
away from children.
•Maximum weight capacity for this stand is 40kg.
•Pay close attention to the weight limits. Ensure all connections are secure and that
the screws, brackets, and mounting points on any monitors are in good condition.
•Safety gear and proper tools must be used.
SAFETY & WARNINGS

DIMENSIONS

Parts:
COMPONENTS

Hardware:
A1 (x4)
A2 (x3)
A3 (x3)
A4 (x2)
A5 (x3)
A6 (x4)
A7 (x2)
A8 (x2)
A9 (x2)
A10 (x1)
A11 (x1)
A12 (x2)
M-A (M5x14) (x4)
M-B (M6x14) (x4)
M-C (M6x30) (x4)
M-D (M8x30) (x4)
M-E (M8x50) (x4)
M-F (x4)
M-G (x8)
M-H (x8)
Note:
This assembly requires a Phillips head screwdriver (not supplied).

Step 1:
Add adhesive feet (A1)to the main base (B1).
Step 2:
Fit the end piece (B5)to the stand (B2).
ASSEMBLY

Step 3:
Align the swivel base (B6) with the stand (B2). Using the Allen key (A10), secure with two A4
screws.
Step 4:
Using the Allen key (A10), secure the main base (B1)to the swivel base (B6) using the three
A2 washers, three A3 washers, and three A5 screws. Ensure to not overtighten the screws.

Step 5:
Use the Allen key (A10)to loosen the screws from the stand’s mounting fixture. This will allow
you to set it at your ideal TV height. Once determined, refit the mounting fixture with the
same screws.
Step 6:
Use the spanner (A11)to fit two A9 nuts, and a Phillips head screwdriver
(not supplied) to fit two A7 screws with two A6 washers.

Step 7:
Using a Phillips head screwdriver, secure the support beam (B3)to the
mounting fixture with the A8 screws and A6 washers.
Step 8:
Use a Phillips head screwdriver to remove the locking screws from the two
mounting rails (B4). Keep these screws nearby as they will be required at a later
step.