Kogan OSTIA Series User manual

FULL MOTION GAS SPRING DUAL
MONITOR MOUNT
(OSTIA SERIES - BLACK)
KADMM46G24A

Read the entire user guide before you start installation and assembly. If you have any
question regarding any of the instruction or warnings, please contact Kogan.com for
assistance.
•Please closely follow the assembly instructions. Improper installation may result in
damage or serious personal injury.
•Safety gear and proper tools must be used. This product should only be installed
by professionals.
•This product is designed to be installed on solid concrete walls, masonry walls or
wood stud walls.
•Make sure that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
•Use the mounting screws provided and DO NOT OVER TIGHTEN mounting
screws.
•This product contains small Items that could be a choking hazard If swallowed.
Keep these items away from children.
•This product is intended for indoor use only. Using this product outdoors could lead
to product failure and personal injury.
IMPORTANT: Ensure that you have received all parts according to the component checklist
prior to Installation. If any parts are missing or faulty, contact Kogan.com tor a replacement.
MAINTENANCE: Check that the product is secure and safe to use at regular intervals (at
least every three months).
SAFETY & WARNINGS
CAUTION: Usage with products heavier than the rated weights indicated may
result in instability causing possible injury.

A (x1)
B (x1) C (x1)
D (x3)
M6x12
E (x2)
M6x10
F (x1)
G (x1)
H (x1)
I (x1)
J (x1)
4mm
K (x1)
5mm
M-A (x4)
M4x12
M-B (x4)
M5x12
M-C (x4)
D5
X2
COMPONENTS

Step 1:
•Firmly hold the two halves of the spring arm together and have another person cut
off the cable tie from around the spring arm.
•Slowly release the pressure on the spring arm and allow it to gradually stretch to its
full extension.
ASSEMBLY
A
WARNING: Stored energy hazard. Take care when releasing the spring arm.

Step 2

Step 3
Too long
Too Short
K
M-A
M-B
M-C
3mm
Top
M-C
M-A
M-B

Step 4:
To properly balance the arm with monitors mounted, adjust the spring tension using the
supplied Allen Key as follows:
Position and firmly hold the arm horizontally as shown. Ask for assistance should you require
it.
If the arm drops, turn the adjustment screw counter-
clockwise until it stays in a horizontal position
If the arm rises, turn the adjustment screw clockwise until it
stays in a horizontal position.
CAUTION: To avoid damage to monitors or mount, always keep the arm in a
horizontal position while adjusting. Again, ask for assistance if required.

Step 5
K
CAUTION: Do not overtighten any of the screws used to assemble or adjust the mount.

Step 6
Note:
Adjust to the desired angle then tighten the screws using the Allen key as shown,
alternating from each screw as you tighten them.
K

NOTES

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com