Installation Instructions
•Remove the exterior and interior packing
•Before connecting the appliance to the power source, let it stand upright
for approximately 2 hours. This will reduce the possibility of a malfunction
in the cooling system from handling during transportation.
•Clean the interior surface with lukewarm water using a soft cloth.
•Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded. To level your appliance, adjust the front
legs at the bottom of the appliance.
•Install away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold or hot ambient
temperatures may also cause the appliances not to perform properly.
•Take care to place the fridge with a 2-3cm gap to the surrounding walls to
allow for proper air circulation.
•Not designed for placement in a basement.
•The appliance is for indoor use only.
Operating your Mini Fridge
It is recommended that you install the mini fridge in a location where the
ambient temperature is between 10-26 . If the ambient temperature is above or℃
below recommended temperatures, the performance of the unit may be
affected. For example, placing in extreme cold or hot conditions may cause
interior temperatures to fluctuate. The range of 2-12°C may not be reached.
The temperature may fluctuate depending on whether or not the interior light is
on or off or whether the bottles are located on the upper, middle or lower
section.
How to set the temperature
There is a mechanical control knob inside the cabinet. Rotate the knob to adjust
the temperature.
There is a TEMP-ADJ knob inside the
mini fridge. The temperature can be
adjusted in the range of 2°C – 12°C in
the cabinet.
The TEMP-ADJ button is set at a
certain point in the fridge during
manufacturing. You can then adjust
this yourself according to your
requirements.
When first using the mini fridge, turn
the knob to “ igh” to lower the
temperature quick.
There is a light switch in the control panel. Press to turn the light on or off.
3
Light button
LED light
Temperature Adjust Knob