Kogan KALED32XXXYB User manual

KALED32XXXYB
KHLED32XXXYB
USER MANUAL

-5-
INSTALLATION
Base Stand Assembly Instruction
Note: Place the TV with the display side down
on a flat surface. Ensure the table or desk
you use provides a flat, totally clean surface.
Use a cloth between the face of the TV and
the table to protect the TV's screen.
1. Locate the bottom bracket into the base
stand and secure in place using the 3 supplied
screw.
2. Gently slide the bracket from the base stand
into the slot in the rear of the TV, aligning the
hole in the bracket with the hole in the TV.
Secure the base stand using the supplied
screw.
WALL MOUNTING INSTALLATION GUIDELINES
For wall mounting with an optional bracket, please read the following instructions in conjunction with the
bracket's instructions. Make sure qualified service personnel perform the operation.
KOGAN bears no responsibility for improper mounting that results in accident or injury.
This television can be wall mounted as follows:
1.Place the LED LCD Television face down onto a solid surface. Please place some soft material over
the front of the screen to protect it from any damage. The LCD panel is a fragile component, and must
be suitably protected when removing the base stand. Be sure that no hard or sharp objects can come
into contact with the screen's surface. Do not exert pressure on the front of the unit at any time, as this
may damage the LCD screen.
2.Remove the screw from the lower part of the television, where the base joins to the TV, and take
away the stand (put the stand and screws somewhere safe for future use).
3.Use the four M4 screws provided to fix the TV onto a wall mounting bracket (not included) via the
four VESA standard holes on the back of the television.
200mm x 100mm VESA
wall mounting hole spacing
and locations
100 mm
200 mm