Kohler TAUT 74013T-4CD User manual

1285744-2A-B 1
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. If possible, install this faucet before installing the lavatory.
3. Inspect the supply tubing for damage and leakage. Replace and maintain as necessary.
4. Observe local plumbing codes.
5. Shut off the water supplies to the fitting.
STANDARD APPLICABLE
Special model meets or exceeds the following at date of manufacture: TIS
1285744-2A-B 4
INSTALLATION INSTRUCTIONS
74013T-4CD Cold Water Lavatory Faucet
74026T-4CD Cold Water Tall Lavatory Faucet
74013T-4CD Cold Water Lavatory Faucet
74026T-4CD Cold Water Tall Lavatory Faucet
TAUTTAUT
ROUGH-IN DIMENSIONS
SERVICE PARTS
**Color code must be specified when ordering.
NOTE: For all Asia pacific regions (excluding China) add SP (SPxxxxxxx**) in front of the part number when ordering.
74026T-4CD
1268507**
1209778**
1209777
1292054
1231450
3008523
74013T-4CD:1024405
1281228
870817
1230578
833438
74026T-4CD:880096
74013T-4CD:836549
1209787
74026T-4CD:836664
74013T-4CD:1280659
74026T-4CD:1280658
20°
120
202
270
420
40 Max.
Ø33~Ø36
G1/2˝
1228834

1285744-2A-B 2 1285744-2A-B 3
INSTALLATION CHECKOUT
Ensure that all connections tightened. Ensure that the
handle is in the off position. Turn on the drain and
main water supply, and check for leaks. Repair as
needed.
Remove the aerator(8) by coin. Turn on the faucet.
Run hot and cold water through the spout for about
one minute to remove any debris. Remove debris from
the aerator. Shut off the faucet and reinstall the
aerator.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
INSTALLATION
Install the mounting stud(2) onto the faucet body
base(3).
Slide the washer(4) over the flexible hose(1) and
mounting stud, and into the groove at the bottom of
the faucet body.
Insert the faucet assembly into the lavatory hole.
Position the faucet. From underside of the lavatory,
place the bracket(5, Rubber washer is on the top)
onto the mounting stud, and tighten the nut(6) by
tool(7) to secure the faucet.
Attach the hose to water supply.
2
3
4
1
5
6
74013T-4CD
157
100
89
18°
40 Max.
Ø33~Ø36
G1/2˝
430
8
7