Kolin Kap-500chcpuv User manual

air purifier

worksforyearsKAP-500CHCPUVAIR PURIFIERUSER MANUALThank you for choosing our product. Please read this user manual before operation and retain for future references. If you have lost this manual, please contact our service centers or visit our website at www.kolinphil.com.ph.

Before useThank you for purchasing our air puriﬁer.02Please spend some time carefully reading this manual before use!The living environment health is increasingly concerned with life quality.The indoor air pollution degree may be above the outdoor air sometimes.Our air puriﬁer can eﬀectively remove some microorganisms, particulate matters and harmful gases, reduce peculiar smell,remove passive smoking and bring you with clean and fresh air by means of high eﬃciency ﬁltrationtechnology combined with Pre-ﬁlter,carbon ﬁlter and HEPA ﬁlter,negativeion puriﬁcation technology. Protect our earth:Do your bit for environmental protectionClassify the waste and do not discard the puriﬁer with other wastesBring the puriﬁer to the nearby professional recovery centerBasic parametersRated voltageProduct model220V~KAP-500CHCPUVRated frequency60HzRated power80WClean air delivery rate (particle CADR)3500m/hMaximum noise67dB(A)(sound power level)Recommended room area 2240m - 57mTo improve the product quality, the product design and conﬁguration may be changed without prior notice and the company reserves the right of ﬁnal explanation.

Important

Dangerous:

Do not let water enter the machine.

Do not use the machine in humid areas, such as bathroom, laundry room

and other places in which the machine may contact water.

Do not clean the product with water and any other liquid or inflammable

detergent to avoid electric shock and/or fire.

Warning:

Confirm whether the voltage marked in the rear part of the product

is consistent with local voltage before switching on the product.

If the power cord is damaged,it must be replaced by the

manufacturer or its maintenance department or the professionals

in similar department to avoid danger. The product is an electrical

appliance and shall not be played with by a child.

People without complete limbs, with sensory or metal disturbance

or lacking relevant experience and knowledge (including children) are

not recommended to use this product, unless otherwise supervised or

guided by the personnel responsible for such people.

Do not block the air inlet or air outlet. For example, do not place the

object in the air outlet or air inlet.

Unplug the power cable if not using the machine for a long time.

Attention:

This product is researched and designed for domestic consumers and

shall not be used outdoors or other inappropriate environment.

Make sure that all have been correctly installed before turningfilters

on the product power.

Do not put any object on the top of the product or sit on the product.

At least 20cm space shall be left in the rear and on both sides of the

product and at least 30cm is left above the product.

Use the original designed exclusively for this product and dofilter

not use any other .filter

Always use the lifting handles on both sides of the product to lift or

move the product.

Do not insert the fingers or other objects into the air inlet or air outlet,

as the machine will be damaged or serious safety risks will be caused.

Do not use this product when using the indoor spray type insect repellant

or in the places filled with inflammable gas.

Do not use this product near gas appliances, heating units or stoves.

Keep stable air flow and temperature in the machine work environment

to ensure normal work of the machine sensor. Do not use perfume,

floral water, liquid vaporizer and other objects with strong smell during

the machine running. Do not place the machine at the air conditioner air

outlet or other environment affecting the air flow stability and

temperature change.

Product appearance description

Display interface

Particle sensor

Air inlet

Base

Power cord

Lifting handle

How to use

Before first use (install )filter

This product is attached with standard . Before using the product,filter

be sure to remove the package. Remove and unpack allfilter filters

according to the following instructions and re-place in the product.

Prompt: Check that the have been firmly placed in correct

filters

manner when taking out or loading the .filters

Note: Be sure to install the in correct position.filters

1. Put the fingers at the

recession of the side panel

and gently pull out the upper

half part of the front towards

your direction. Lift the hook

at the bottom of the panel

and pull it out from the

bottom of the product.

2. Remove all in

filters

the product.

3. Remove all packages of

the .filters

4. Put back the HEPA filter

inside the product.

Note: Make ensure that the

side with drawstring is

towards you.

5. Put the modified activated

carbon inside the

filter

product.

Note: Make ensure that the

side with drawstring is

towards you.

6. Put back the Aluminum

Prefilter

inside the product.

Note: Ensure that the

side with drawstring

towards you.

7. Turn four rotating buckles

to horizontal position.

8. Load back the front panel

and install the bottom hook

in place and then push the

panel to the machine body.

Switch on

Insert the plug into the socket.

All key indicator lights will be on successively when you hear ting sound.

Then, all indicator lights other than the indicator light of the on-off key

will be off again.

Use method

Description of touch key operations

Touch keys

Icon Key name Functional description

Run/Stop Turn on/off the air purifier

Manual air flow speed

mode

Manually select high/medium/low

air flow speed

Anion on/off Turn on/off anion

Timing set Set and cancel timing function

UV on/off Enable/disable UV function

Auto mode Enable auto mode

Reset filter reset function

Child lock Enable/disable child lock

function

Sleep mode Enter/exit sleep mode

Press “On/Off” once. The product starts and enters the auto mode.

The user may make corresponding operation according to desired mode.

Press “ speed” to manually select high, medium and low;Air flow

This function may be enabled only after “ speed” mode is manuallyAir flow

selected.

Note: The anion function manually enabled is automatically disabled at

most 1h after working.

Timing set: increase timing by 0.5h and set timing for at most 8h. Long

press “Timing” to quickly increase the time. Stop pressing, the displayed

time is flashing three times and the set timing is determined.

Timing cancel: press “Timing” once after the timing is set to cancel the

timing function.

This function may be enabled only after “ speed” mode is manuallyAir flow

selected.

Note: The UV function manually enabled is automatically disabled at

most 1h after working.

Detect the air quality and peculiar smell, automatically adjust the air flow

speed and clean the air when the product is running in “Auto” mode.

Long press “Reset” 3s in the on status after replacement. Thefilter

indicator light is flashing three times and then off after reset.

Note: If the is replaced before the replacement indicatorfilter filter

light is on, the timer will not be reset and will continue to calculatefilter

the service life of previous . Therefore, the filter replacementfilter

indicator light may be on soon.

Long press “Child lock” key 3s to enable the child lock function.

Long press “Child lock” key 3s again to disable child lock.

Note: The other key operations are invalid after the child lock function

is enabled.

Press “Sleep” once and the equipment enters sleep mode.

Press “Sleep” again to exit the sleep mode.

Note: The timing, anion and UV functions are automatically disabled

after the sleep mode is enabled.

Digital Display Mode

HEP A

filter

replacement

indicator light

Auto

mode

indicator

light

Air flow speed

indicator light

Low Medium High Timing

display

Child lock

indicator

light

Anion

indicator

light

Air flow speed

indicator light

Time

indicator

light

indicator

light

Air quality indication

＜75 Very good

75~150 General

＞150 Poor

* The air quality indication value only represents the air quality relative

status rather than actual pollutant content.

HEPATVOCSpeed Time

AnionUVTimingSleepChildlockAir flowspeedAutomodeOn/Off10

Remote control

The functions are the same with touch keys

Daily care and maintenance

To keep the machine running in best status, you are recommended to

regularly clean the machine.

Be sure to cut off the power when cleaning, maintaining and replacing

the .filter

Wipe the outside of the machine with clean and soft towel. Open the

front panel, take out the and use the soft brush to clean thefilter

air inlet grid.

Do not clean any part of the product with gasoline, alcohol, bleach

and other chemical solvents and corrosive cleaners.

Clean the particle sensor

It is recommended to clean the particle sensor every two months.

Properly increase the cleaning times if the local air quality is very severe.

Note: In case of large changes in the indoor temperature and humidity or

high humidity, the condensate water may be formed on the air quality

sensor, resulting in sensor misoperation.

Even though the air quality is high at this time, the display panel may also

display general or poor air quality. In this case, clean the air quality

sensor and it is recommended to set the wind speed in manual mode.

Refer to “Reset” function to reset the timer afterfilter filter

replacement.

The other than primary shall not be washed.filters filter

Consult the local dealer to purchase supporting materials for timelyfilter

replacement according to your actual situation, the needs of each customer

and different use frequencies of the machine in various occasions.

Digital Display Mode Common trouble shooting

Confirmation matters before fault declaration

Confirm the following matters before the product is entrusted to the

customer service center for repair due to exception.

Status  matter Measure

The product cannot

be started

Is the power cut? Re-operate er c the power

Does the power plug fall off? Re-operate er  the power

plug

Is the power socket connected? Re-operate er replacing the socket

Is the front panel not closed

tly?

 that the front panel has been

closed according to ins

Red HEPA indicator

light is normally on

Is the reset button pressed for

more than 3s in the reset er

er replacement?

Press the reset button for more than 3s

to reset er er replacement.

The product has

peculiar smell

Is the primary er polluted? Clean the primary er

Does the er have peculiar

smell?

Purchase and replace the er

There is abnormal

sound

Is there “peep” sound? “Peep” sound will be generated when

the anion is released. It is normal

sound in product opera Please rest

assured.

Excessive product

sound

Are all packages of the ers

removed?

Ensure that all packages have been

removed.

The air quality

indica is always

more than 150

Is there unfound dust or

peculiar smell inducing

substance indoors? Is the color

changed er the machine is

moved to a clean room? Are the

air quality sensor and smell

sensor regularly cleaned?

Clean the  or smell sensor. If the

red light is s always on er the

dust/smell sensor is cleaned and

moved to a clean room, the sensor/line

may be abnormal. Please contact the

customer service center.

The air quality

indicator light is

above 74, but the

air volume is s

unchanged

Is it in auto mode status? Set to auto mode.

The air volume will not be changed

automaally in manual wind speed

mode.

BRANCH ADDRESS TEL. NO. Bacolod Door A2 and A3 UTC Building, Alunan St., Barangay Singcang, Bacolod City (034) 433-0031 Cagayan De Oro Door No. 3 De Oro Land Building, Julio Pacana St., Puntod, Cagayan De Oro City (088) 856-4672 Cebu Unit 6A, Geson Building, D.Jakosalem corner F. Ramos St., Cebu City (032) 253-9997 Dagupan 107 Caranglaan District, Dagupan City, Pangasinan (075) 523-2832 Davao Door No. 5 Belle Fran Arcade, E. Palma Gil St., Barrio Obrero, Davao City (082) 227-7063 Iloilo Door 4 TDK Realty Development Corporation Building, South Fundedor St., Barangay Fundedor, Molo, Iloilo City (033) 336-1970 Pampanga Mexico Gold Commercial and Residential Building, Jose Abad Avenue, Lagundi, Mexico, Pampanga (045) 455-2934 Zamboanga Door No. 5, Varmall Building, Veterans Avenue, Zamboanga City (062) 992-2493 KOLIN PHILIPPINES INT’L., INC.HEAD OFFICE:1854 Sta. Rita St., Guadalupe Nuevo, Makati CityTel.: (632) 8851-2711 (632) 8851-2712 (632) 8851-2715Fax: (632) 8852-2170PLANT:Block 3 Lot 5 Main DriveFirst Cavite Industrial EstateBrgy. Langkaan 1, Damariñas CityCaviteTel.: (632) 749-2118Fax: (046) 402-0793

air purifier

worksforyears