4 5
INSTALLATION REVERSING THE DOOR SWING
Before using your fridge
The temperature in the fridge will depend on:
- The temperature in the surrounding area.
- The frequency and duration when the door is open.
- Contents in the fridge
• Remove the exterior and interior packaging, including protective foam on door panels.
• Check to be sure the all parts are included.
• Before connecting the appliance to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installation of your fridge
• Place your appliance on a floor that is strong enough to support the appliance when fully loaded. To
level your appliance, adjust the legs at the front of the appliance.
• Allow 5 inches of space between the back and sides of the appliance, which allows the proper air
circulation to cool the compressor.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause
the appliance not to perform properly.
• Avoid locating the appliance in moist areas. Too much moisture in the air will cause frost to form
quickly on the evaporator.
• Plug the appliance into an exclusive properly installed grounded wall outlet. Do not under any circum-
stances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified electrician or an authorized products service
center.
WARNING!
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized products service center.
HOW TO OPERATE
Temperature control is provided by a knob inside the unit.
There is an OFF position (O) and 5 control marks.
• high setting is (next to the O position) is 32°F / 0°C
• low setting is 50°F / 10°C
Each increment will be 4.5°F / 2.5°C apart.
The following actions can increase the cooling function of this product:
1. When you use the unit for the first time, allow the unit to operate continuously for 12-18 hours.
2. Increase the amount of space between the items placed in the unit. Do not overload.
Before reversing the door, the power must be shut off. All parts removed must be saved to do the
reinstallation of the door.
This unit has the capability of either opening the door from the left or right side. To reverse the
opening direction, please follow these instructions.
1. Remove the upper hinge cover (1) first.
2. Remove the two screws (2) that hold the upper hinge (3) (right side) to the frame. Take away the
upper hinge (3).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws (7) that hold the lower hinge (4) and remove hinge (4).
5. Remove the left front leg (8) and transfer it to the right side.
6. Remove the plug (5) and move to the right side.
7. Before placing this lower hinge (4), remove the bolt-pin (6) and reverse the direction of the lower
hinge (4). Then install the lower hinge onto the left side of the lower frame with two screws (7).
8. Insert the bolt-pin (6) to the lower hinge (4).
9. Set the door to its place making sure the door seat at the lower hinge (4).
10. While holding the door in the closed position secure the upper hinge (3) in the top frame of left
side with two screws (2). Please remember that do not tighten the screws until the top of the door is
leveled with the counter top.
11. Install the cover (1) on the upper hinge.