Korg volca kick Use and care manual

volca kick System Firmware Update Instructions
1
System Firmware Update Instructions
Do not playback the system update file on any speaker or headphone system as this could lead to
damage to equipment and/or hearing loss. Korg or any of its affiliates will not accept responsibility for
any damages, personal loss or injury that may result from playback of the file.
What you will need
You will need the following to perform your update.
An audio player or personal computer capable of audio playback
A stereo mini-jack audio cable
AC adapter KA-350 or six AA batteries
Make sure the batteries are brand new if using alkaline or fully charged if using NiMH batteries.
volca kick will not enter update mode if the batteries are depleted.
Preparations
1. Unzip the file “volca_kick_updater_0105.zip”.
If using an audio player, transfer the file volca_kick_sys_0105.wav from your computer to your audio
player.
Do not playback the system update file on any speaker or headphone system as this could lead
to damage to equipment and/or hearing loss.
2. Check the current version
Turn the power on while pressing the REC button.

volca kick System Firmware Update Instructions
2
Before system version 1.05
If the current system is before version 1.05, the
display will be lit as shown. Your volca kick is not
up to date. Proceed to step 3.
System version 1.05
If the current system is version 1.05, the display
will be lit as shown. Your volca kick is already up
to date.
3. Connect the audio output of your playback device to the SYNC IN connector on your volca kick.
SYNC IN
Audio Out
Before
ver. 1.05
ver. 1.05

volca kick System Firmware Update Instructions
3
Perform the update
1. Turn the power on while pressing the FUNC and PLAY buttons.
“UPdt”will be displayed to show your volca kick has entered update mode.
2. Start the playback of volca kick_sys_0105.wav to begin updating.
Make sure the volume of the playback device has been turned up.
STEP LEDs 1-16 will indicate the update progress.
Make sure the update file is played from the beginning.
When using a computer, any other system sounds (e.g. email notification) will cause the update
to fail. Make sure all other applications are shut down and do not operate you computer during
the update.
The update will take approximately thirty seconds. Do not turn your volca kick off or stop
playback while update is in progress.
If the update fails, the knobs will start blinking. If this happens, observe “Tips”at the end of this
document and repeat the update from step 1.
3. When the update has been successfully completed, “End”will be displayed. Now, turn the power off.

volca kick System Firmware Update Instructions
4
4. Go back to step 2 of “Preparations”and check that your volca kick has been updated.
Tips
Update may fail with some audio players, computers or software. If this is the case, please try with a
different device.
If you are having trouble with the update, please check the following:
Check the current system firmware version. If it has already been updated, you will not be able
to update again (it will also be unnecessary).
Make sure the volume of the playback device has been turned up.
Please note that some devices which have very high output levels may fail because of it. If this
is the case please try turning the volume down and start the update process again.
Make sure all functions that affect the playback sound, such as cross-fade and EQ, are
disabled.
Make sure the update file is played from the beginning.
Check the connection from your playback device to your volca kick.
When using a computer, any other system sounds (e.g. email notification) will cause the update
to fail. Make sure all other applications are shut down and do not operate you computer during
the update.