KozzHogar SBD80 User manual

Notice: Make sure the board side with edge
band on board (7) and (8) faces in the
same direction

Notice: Make sure the
grooved side of board (6)
faces in the same
direction as the side of
board (7) and (8) without
edge band
Notice: Make sure
board (7) faces to board
(6) with the side that
have no Cam Lock holes

Note: This side has
no Cam Lock holes
Notice: Drawer support panel (9) has edge band
on its front side, and its front side faces to the
front of the drawer.
Notice: Arrow hole on
the rail points to the
front of the drawer
Step 3.1, Securing the drawer rail front end with
Screw D, make sure the drawer rail front end
aligns with the drawer support panel (9) front
side
Step 3.2, Securing the drawer rail back
end with Screw D
Note: This side has
Cam Lock holes
Notice: Arrow hole on
the rail points to the
front of the drawer
Step 3.3, Securing the drawer rail front end with
Screw D, make sure the drawer rail front end
aligns with the drawer support panel (9) front side
Step 3.4, Securing the drawer rail back
end with Screw D
Turn over the board (9) and install
drawer rail on the other side

Shorter side,
connects with
board (6)
Notice: All boards only
face front with the side
that has edge band
Notice: This side
has Cam Lock
holes

Counting from the right, screw (D) into
the 8th round hole refer to the diagram
above

Counting from the left, screw (D) into the 8th
round hole refer to the diagram above

Make sure board (10) has
the wood texture side face
inside