Installation description
VDA Cable 68678 Jaguar 18 pin 2002-
1st: Lift up the armrest at the centre console and remove the re-
taining screws. Remove the armrest and lift out the cubby hole.
2nd: Locate the yellow 18 way plug. This can be found at the rear
of the inside centre consol.
3rd: Connect the VDA cable to the 18 way plug, and plug in the
other end through an interface adaptor to the carkit.
4th: Please install
the small Coil be-
tween the bullets
on the white and
white/black wires
on the interface ca-
ble. Without this coil
the sound will be
distorted.
This lead allows the volume control on the steering wheel to con-
trol the telephone level.
When the VDA cable is installed correctly it will redirect your call
through the car front speaker.
Please remember to use a carkit interface adaptor to connect the
carkit to the VDA cable.
Interface LeadsInterface Leads
Product description
VDA Cable 68678 Jaguar 18 pin 2002-
Interface Leads are used for car stereos with a Line-In func-
tion or VDA preparation. It enables the use of the car speakers
when answering/making calls from your cell phone. Thereby
using the radios build-in mute function.
Speaker-function: This is achieved by connecting the carkit di-
rectly to the cars Line-In input/VDA connector. By using the
radios built-in relays the telephone conversation is send
through the car speakers while the radio is muted. This way
you will achieve a perfect hands free sound without interfer-
ence from the car radio.
For a complete cable-set two item no. is required. The first is
a car-specific Interface cable. The second is a carkit-specific
Interface adaptor cable .
Power supply of the carkit: All Interface cables are delivered
with a power connector for the carkit, that way you avoid cut-
ting the cars wiring loom.
Please check the radio instruction manual for special issues
regarding the connection and set-up of the radio, when con-
necting a carkit.
See our complete Interface program on
www.kram.dk
