Kramer K-POD302 User manual

K-POD302 Quick Start (P/N: 2900-301100QS REV 3)
P/N:
2900- 301100QS
Rev:
3
Scan for full manual
K-POD302 Quick Start Guide
This guide helps you installand use your K-POD302 for the first time.
Go to http://www.kramerav.com/downloads/K-POD302 to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check what’s in the box
K-POD302 Mounting Enclosure for Kramer 3−Gang Size Products
4 M3X8 screws
2 4x1/2" screws
1 Quick start guide
Step 2: Get to know your K-POD302
#
Feature
Function
1
Mounting Frame
For mounting Kramer 3−gang size device.
2
Table Screw Openings (x2)
For attaching the K-POD302 onto the surface.
3
Cable Opening
Use to pass the cables either through the rear side of K-POD302 or under the
table/podium (if the surface has a cut-out opening).
4
Device Mounting Screw Openings (x4)
For attaching the Kramer 3−gang size device to the K-POD302.
Step 3: Mount the K-POD302 onto a surface
If you plan to pass the cables under the table you need to drill a hole in the table before mounting K-POD302 onto the surface.
If you plan to pass the cables through the rear opening, skip the first part in this section.
To drill a hole in the table:
1. Place the K-POD302 on the surface
and carefully mark the opening area
so it fits the opening in the K-
POD302.
2. Using any standard cup bit drill, with a
diameter of 30mm (1.2”), drill a hole in the
table in the desired location.
3. Clean the table surface.
Take care not to damage the table.
Kramer Electronics is not responsible
for any damage caused to the table.

To attach K-POD302 to the table surface:
1. Place the K-POD302 on the table in
the desired location (if you cut a hole
in the table, fit the underside opening
to that hole).
2. Pass the 2 M4x1/2” screws (supplied)
through the table screw openings and
tighten them to fix the K-POD302 to the
table.
Step 4: Attach RC-74DL to the K-POD302
RC-74DL is used here as an example. Other 3-gang Kramer products can also be mounted in K-POD302.
To attach RC-74DL to the K-POD302:
1. Connect the cables to the rear panel of the
RC-74DL and pass the cables through the
cables opening.
2. Place the RC-74DL panel over the
K-POD302 frame and pass the 4 M3x8
screws (supplied) through the RC-74DL
holes and mounting screw openings and
tighten them.
3. Position the RC-74DL faceplate over the
panel and tighten with the 4 RC-74DL
faceplate screws (supplied with RC-74DL).