Krix Seismix 1 User manual

The Seismix 1 subwoofer has been designed to complement existing Stereo or Home
Theatre systems where size and placement of the subwoofer is an important consideration.
The amplier module and 10” bass driver are identical to that used in the Seismix 3, however
they have been re-designed in a smaller enclosure to allow for installation in a cabinet or
where there is a space restriction. The Seismix 1 is an Explosive Experience.
Seismix 1: specications
Drivers
Bass Driver Nominal 255mm (10”) diameter paper cone driver developed for
high level, low frequency reinforcement
Electronics
Amplier Powe 200 watts RMS into the nominal 4 ohm driver
Maximum instantaneous power 400 watts
Amplier S/N >70dB
Distortion - Input to Speaker <0.1% – @ 80 watts RMS
Line Level Inputs Left Input (mono) Lo – 900mV RMS for maximum output
Hi – 100mV RMS
Left + Right Input (stereo) Lo – 450mV RMS for maximum output
Hi – 50mV RMS
General
Frequency Range 22Hz – 150Hz (-6dB) in room response
Output 120dB maximum SPL in room response
Auto Power On / Off 15 minute delay before switching to standby after no input signal
Phase Select 0° or 180° (relative to input signal)
Cabinet
Enclosure Type Bass Reex, front vented
Dimensions 365mm high x 315mm wide x 340mm deep
Material 17mm MDF
Finish Vinyl or lacquered timber veneer
Weight 15kg
Due to continued development specifications may change without notice