Krugg SOL Operation manual

Wall Mirror Installaon &
User Guide
SOL

SOL - Specificaon Sheet Krugg Reflecon USA | 1957 Pioneer Rd Unit G | Hunngdon Valley | PA 19006 Page 1 of 7
DANGER
Risk of personal injury. To avoid possible electrical shock, the electricity must
be turned off at the circuit breaker or fuse box before aemng any
installaon procedure. The mirror must also be properly grounded.
To reduce the risk of burns, fire, electric shock or injury to persons. Use this
furnishing only for it’s intended use as described in these instrucons. Do
not use aachments not recommended by the manufacturer. Never drop or
insert any object into any opening. Do not use outdoors.
GROUNDING INSTRUCTIONS
This product must be connected to a grounded metal, permanent wiring
system, or an equipment-grounding conductor must be run with the circuit
conductors and connected to the equipment-grounding terminal or lead on
the product.

SOL - Specificaon Sheet Krugg Reflecon USA | 1957 Pioneer Rd Unit G | Hunngdon Valley | PA 19006 Page 2 of 7
WARNING
All fings must be installed in
accordance with current IEE wiring
regulaons. If in doubt, consult a
qualified electrician.
Switch off the electrical supply at the
main circuit board BEFORE installaon
and maintenance.
Suitable for Bathroom Zones 2, 3 and
non bathroom/dry areas. See diagram
below.
NOT suitable for above baths or Zone 1
not for installaon in Saunas, Steam
Rooms or Shower Cubicles.
DO NOT fix to damp or conducve
surfaces.
Suitable for indoor use only.
Site well away from curtains and fabrics.
Never cover the mirror.
Switch off aer use.

SOL - Specificaon Sheet Krugg Reflecon USA | 1957 Pioneer Rd Unit G | Hunngdon Valley | PA 19006 Page 3 of 7
IMPORTANT - BEFORE YOU BEGIN
Inspect the product immadiately
upon receipt for transit damage or
missing parts.
Handle the product with care and
protect against knock to all sides and
edges of the glass.
Make sure that you have all the tools
you need to complete the job. (SEE
BELOW)
Ensure ther are no hidden pipes or
cables in the wall before drilling.
If drilling holes in ceramic les use a
piece of masking tape on the le to stop
the drill bit from slipping.
Aercare Instrucons
Clean using a so dry cloth only
when turned off.
Never use cleaning agents or abrasive
materials.
Do not allow moisture to come into
contact with lamps.
TOOLS USED

www.kruggusa.com
SOL - Specificaon Sheet Krugg Reflecon USA | 1957 Pioneer Rd Unit G | Hunngdon Valley | PA 19006 Page 4 of 7
ELECTRICAL WIRE INFORMATION
The Lead Contains 3 Wires:
COPPER WIRE (GREEN) = GROUND WIRE...Connect to GROUND WIRE in your box, or to the
box as a ground.
WHITE (or BROWN) = NEUTRAL WIRE... Connect to the WHITE NEUTRAL WIRE in your box.
BLACK (or BLUE) = HOT WIRE... Connect to the BLACK HOT WIRE in your box.
The SOL wires will be connected to your 120 Volt electric box. This should be placed in the wall,
behind your SOL Mirror. The suggested method for placement is towards the center, however
there is flexibility with the lead wire.

www.kruggusa.com
SOL - Specificaon Sheet Krugg Reflecon USA | 1957 Pioneer Rd Unit G | Hunngdon Valley | PA 19006 Page 5 of 7
B
A
4
0.6mm
3
INSTALLATION GUIDE
1
x
y
H
2
wall tiles
2-3mm
6
B
A
5
wall tiles
2-3mm
6
5
Measure
distance
between
anchor
posions
Mark hole
posions
on the
wall
ready for
drilling
Carefully
drill
each of
the holes
Insert
anchors
into
predrilled
holes
Drive in
the
screws
leaving
2-3mm
showing
Hang the
mirror
with care
onto the
screws
making
sure it’s
secure
B
A
y
x

www.kruggusa.com
SOL - Specificaon Sheet Krugg Reflecon USA | 1957 Pioneer Rd Unit G | Hunngdon Valley | PA 19006 Page 6 of 7
Dimensions
Height: 42”
Width: 42”
Depth: 1-9/16”
MO DELA B C D E F
SOL42 42 42 4-1/2 1-1/4 1-3/4 1/4
FRONT & SIDE
MO DELA B C D E F
SOL42 28-1/2 23-1/2 28-1/2 14-1/4 1-3/4 1/4
BACK
FRONT BACK
SIDE
F.
E
B. D.
C.
A.
A.
B.
D.
C.

Subject to the terms and condions specified herein, Krugg Reflecons USA LLC ,
(“KRUGG”) hereby extends a limited lifeme warranty (this “Limited Warranty”) to
original Purchasers (as defined below) of the Krugg LED Medicine Cabinet (the “Product”)
with respect to certain specified components of the Product. Specifically, KRUGG, by this
Limited Warranty, warrants that, for the duraons specified herein, Products purchased
directly from KRUGG or KRUGG’s authorized retailers will be free of defects in the
material and workmanship of the Product’s electrical components, glass, mirrors, and
certain mechanical components, which defects would cause the Product to substanally
fail to funcon when subject to normal use.
LIMITED WARRANTY
The interior is constructed of mirrored glass and aluminum. Use only a damp cloth
to clean. Ammonia or vinegar-based cleaners can damage mirrors.
When cleaning, spray the cloth, not the mirror, or surrounding surfaces. Do not use
abrasive cleansers on any part of the light fixture.
USE AND MAINTENANCE
•
•
Subject to the terms and condions specified herein, Krugg Reflecons USA LLC,
(“KRUGG”) hereby extends a limited one-year warranty (this “Limited Warranty”) to
Commercial Purchasers (as defined below) of the Krugg LED Lighted Mirror (the
“Product”) with respect to certain specified structural components of the Product.
Specifically, KRUGG, by this Limited Warranty, warrants that, for a one-year period,
Products purchased directly from KRUGG or KRUGG’s authorized retailers will be free of
defects in the material and workmanship of the Product’s electrical components, glass
and mirrors, which defects would cause the Product to substanally fail to funcon when
subject to normal use.
Addional Warranty Informaon can be found @ hp://www.kruggusa.com
For any installaon and warranty related issues, contact us at [email protected]
COMMERCIAL WARRANTY
www.kruggusa.com
SOL - Specificaon Sheet Krugg Reflecon USA | 1957 Pioneer Rd Unit G | Hunngdon Valley | PA 19006 Page 7 of 7