Kuhne electronic MKU UP 2424 B Use and care manual

shop.kuhne-electronic.de
Kuhne electronic GmbH
Scheibenacker 3 Telefon: [phone] / 800640
95180 Berg – Germany E-Mail: [e-mail] Solutions for the wireless world
MKU UP 2424 B – Firmwareupdate
Seite / page 1
MKU UP 2424 B
30.07.2019
Firmware-Update

shop.kuhne-electronic.de
Kuhne electronic GmbH
Scheibenacker 3 Telefon: [phone] / 800640
95180 Berg – Germany E-Mail: [e-mail] Solutions for the wireless world
MKU UP 2424 B – Firmwareupdate
Seite / page 2
Bootloader Settings
- Install the BOOTLOADER GUI on your PC
- Connect the MKU UP 2424 B with your PC and check the COM port number of the adapter.
- Start the BOOTLOADER GUI and make the settings (see picture). Select the COM port number of your adapter.
Select Flash Hexfile.
- Apply supply voltage to the MKU UP 2424 B.
- Enable „Send this Pre-String“ and write the command FU in the blank field
- Press „Connect to Bootloader“

shop.kuhne-electronic.de
Kuhne electronic GmbH
Scheibenacker 3 Telefon: [phone] / 800640
95180 Berg – Germany E-Mail: [e-mail] Solutions for the wireless world
MKU UP 2424 B – Firmwareupdate
Seite / page 3
Update Procedure
Nextion
NX4024T032
- If the BOOTLOADER GUI detects the MKU UP 2424 B correctly, the BOOTLOADER GUI looks like below.
- Press „Program Flash“ and wait until the update is finished.
- Press „Start Application“
- The firmware update is finished.
- Disconnect the supply voltage and press „Exit“.

shop.kuhne-electronic.de
Kuhne electronic GmbH
Scheibenacker 3 Telefon: [phone] / 800640
95180 Berg – Germany E-Mail: [e-mail] Solutions for the wireless world
MKU UP 2424 B – Firmwareupdate
Seite / page 4
Notes