KWIK GOAL KWIK FLEX 2B1505 User manual

NZ458 Rev. 01/10/20
Parts
1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or
damp packaging may damage contents.
ASSEMBLY INSTRUCTIONS FOR 2B1505 & 2P1504 KWIK FLEX LITE GOALS
®
140 Pacific Drive Quakertown, PA 18951
800-531-4252 Kwikgoal.com
2020 Kwik Goal Ltd. ©
Goal Frame & Net (1)
Carry Bag (1) Tension Rod (4)

NZ458 Rev. 01/10/20
2. Open base frame by swinging outward until button locks
in place in center connector as shown. Use care to keep
net from getting pinched in moving parts.
Open until button locks in place
Base Frame
Base Frame
Center Connector
Base Frame
Base Frame
Center Connector
3. Pull left and right rear base until button locks into place
on right and left center base. Do not force parts. Parts
should move freely, if parts do not, look for points where
net may be caught on frame.
Pull until button locks in place
Pull
Pull
Left Rear Base
Right Rear Base
Right Center Base
Left Center Base

5. Add tension rods to base as shown. Tension rod at front must go
through net pocket and elastic strap. Place front tension rods into
base holders prior to attaching net loops.
Tension Rod
Base
Rear Tension Rod
Front Tension Rod
Front Tension Rod
Rear Tension Rod
Net Pocket
Elastic Strap
Net Pocket
Elastic Strap
Open until button is engaged
Left Base
Left Rear Base
4. Open left and right bases by swinging outward until button
locks in place in left and right rear base.
Left Base
Right Base
Left Rear Base
Right Rear Base

6. Connect top corners of net to tension rod in front by sliding
net loop over end of tension rod.
7. Connect backdrop corners of net to tension rod in rear
by sliding net loop over end of tension rod.
NZ458 Rev. 01/10/20
Net Loop
Tension Rod
Net Loop
Tension Rod
Go to Kwikgoal.com for additional product information.