Kyla KSEN-231 Instructions for use
PRODUCT DESCRIPTION
The Kyla Smoke Alarm is a stand-alone
smoke alarm with an in-built
3.0V 1650mAh
Lithium battery that can last for 10 years. It
utilizes a photoelectric sensor that allows
it to be more sensitive to detecting slow
smoldering fires which generates thick
black smoke and little heat.
123
© 2022 Aztech Technologies Pte Ltd. All rights reserved.
PLACEMENT TIPS
NOTE
• Smoke alarm should be installed on ceiling along an escape route
(e.g living room)
• To prevent false alarm, avoid installing in kitchens and bathrooms.
• For multi-storey homes, minimum 1 smoke alarm per storey is
recommended.
• Remove “silicon protection cover” before use.
Smoke Alarm
Location
Button
Power button
Hush button
(Gray Area)
Smart Smoke Alarm ESG.pdf 22/06/2022 14:46:43
BUTTON
ACTION REMARKS
Press Power button and hush button at the
same time (red LED flash rapidly with alarm) Test Mode
Red LED flash every 10 seconds (9min-exit) Hush Button
Thank you for using Kyla product! Please keep this Easy Start Guide for future
use. For support or help, visit kylaconnect.com
TEN-YEAR LIMITED WARRANTY
The Manufacturer warrants its enclosed smoke alarm to be free from
defects in materials and workmanship under normal use and service for a
period of 2 Years from Date of purchase and 10 Years Battery Warranty. The
Manufacturer makes no other express warranty for this smoke alarm. No
agent, representative, dealer or employee of the company has the authority
to increase or alter the obligations or limitations of this Warranty.
The Manufacturer shall not be obligated to repair or replace units which are
found to be defective because of damage, unreasonable use, modifications,
or alterations occurring after the date of manufacture. In no case shall the
Manufacturer be liable for any consequential or incidental damages for
breach of this or any other Warranty, expressed or implied.
The warranty is not valid unless the purchaser registers online within 14
days of purchase (with the proof of purchase). Thank you dear customer for
purchasing our product! Please register your warranty online at:
https://kylaconnect.com/e-warranty
To obtain service under this warranty, please contact Service Center at:
Tel: +65 6594 2288
Address: 31, Ubi Road 1, #01-05, Singapore 408694
Service Hours: Monday to Friday, 9:00am – 5:30pm
(Closed on Weekends & Public Holidays)
Email: [email protected]
INSTALLATION GUIDE
Ceiling mount with screw.
LED STATUS INDICATOR
NOTE
ACTION REMARKS
Red LED flash rapidly with alarm Smoke Warning
Red LED flashed once every 43 seconds and
alarm once Low Battery Warning
Green LED flash 3 times every 43 seconds Hysteresis Mode
456
EASY START GUIDE
SMOKE ALARM
TECHNICAL SPECIFICATIONS
Model KSEN-231
Power supply
Alarm Current
≤100mA
Sound Level 85 dB(A) at 3 meters
Smoke Sensor Photoelectric Sensor
Dimension ø56.6mm x H50.5mm
Operating Temperature 0 to 45°C
Non-Operating Temperature -25 to 70°C
Operating Humidity 0% to 95% Relative Humidity
(non-condensing)
Non-Operating Humidity 0% to 95%
Regulatory Compliance EN 14604:2005
1
3
2
4
Press the hush button for 0.5sec, red LED will
flash rapidly with alarm.
(If LED does not flash, please remove the main
unit and attach to the celling mount bracket
again)
Rotate clockwise until click.
Plastic
Anchor
Alignment
marks
Smart Smoke Sensor ESG_Amen.indd 2 20/10/2023 14:46:44
•
•
Shouldthedevice fail to operatecorrectly,please contact us.
•
Shouldthedevice indicatea battery fault warning, replace the smoke
alarm.
PACKING CONTENT
To confirm that the alarm is operational, perform a regular button test.
Smoke Alarm x1
Bracket x1
Screws x2
Easy Start Guide x1
Silicon Sleeve x1
Warranty Card x1
Plastic Anchors x2
Standby Current
≤10µA
3.0V 1650mAh lithium battery
(non-replaceable)
