DOCUMENTAZIONE TECNICA STATO DI REVISIONE CAPITOLO IN CONFORMITA’
CON ORIGINALE
APPROVATO
BANCO: SHUFFLE KW ORD. DATA DOC. INOLTRO ORD. DATA DOC. INOLTRO
N° DOC IM000217 A 01/10/2019 D
N° CAP. - B 29/09/2020 EFOGLIO: 8
CAPITOLO: - C F
UNPACKING AND MOVEMENT
TRANSPORTATION
The display cabinet is contained in a specially crated package that enables transportation
by the use of fork-lift trucks.
For each subsequent handling of the cabinet, the use of the wooden platform is
recommended.
The unit is shipped anchored onto a wooden base and protected by corner posts, cardboard
top and nylon wrapping.
It must only be handled using a fork lift truck with adequate power to the load.
Positioning the appliance horizontally or on its side or upside down is to be strictly avoided.
Handling is reserved to the authorised after-sales service.
The equipment MUST be kept vertical.
The appliance, equipped or not with its packaging, must be carefully stored inside
warehouses or premises protected from bad weather, atmospheric agents and direct
exposure to sunlight at a temperature between 0 and +40 °C.
STORAGE AND DISMANTLING
WARNING! Use protective gloves during unpacking and installation operations.
During unloading and movement operations, avoid tilting the machine and avoid sudden manoeuvres.
The unit is shipped anchored onto a wooden base and protected by corner posts, cardboard top and nylon wrapping.
Keep all packaging away from children.
For each subsequent handling of the cabinet, the use of the wooden platform is recommended.
Carefully remove the packaging, taking care not to damage the components and not to throw away those that will be needed
for assembly.
ATTENTION! After unpacking, check that the appliance has not suered damage during
transportation.
WOODEN BASE
CARDBOARD CORNERS
POLYSTYRENE
CAGE WOODEN PACKAGING
CARDBOARD CORNERS
NYLONE COVERING
NYLONE COVERING
To unpack the bench proceed as follows:
1. Unscrew the screws and remove the wooden cage
2. Remove the plastic cover
3. Unscrew the reinforcement and remove the part of the base indicated in the gure.
4. Using forklift the bench.
5. Remove the wooden base.
6. Position the bench adjusting the feet.
